FOX digital Micron MX Digital Bite Alarm User Guide

FOX digital Micron MX Digital Bite Alarm

OVERVIEW

FEATURES

• Weatherproof Sealed Case
• Dual Step Sensitivity
• Digital Circuitry
• D-Tec™ Sensing System (DTSS)
• Low Battery Drain
• CNC Machined Roller wheel – Tru-Run™
• Multicolour (x6) LED

FITTING THE BATTERIES

1. Turn off the unit prior to fitting or replacing the batteries
2. Using a cross-head screwdriver unscrew the two battery cover screws.
3. Pull the tab upwards from the top of the battery cover.
4. Take care removing the batteries. Insert new batteries and ensure correct polarity.
5. For best weatherproofing, ensure the battery cover has a good seal by firmly pushing lip into the bottom edge of the case and pivoting it into position.
6. Re-fit cover and screws.

SWITCHING ON/ OFF

• Push down the power switch and release to activate the unit.
• Push up and release the power switch in the top position to deactivate the unit.

Please note:

The unit does not beep when switched on or off. Please ensure the unit is switched off before attempting to fit the MX hardcase. Do not use excessive force when fitting the hardcase as this may result in damage to the alarm. SOCKETS

• Power Out Socket Allows Fox Illuminated Bite Indicators to be powered directly from the Micron. The Illuminated Bite Indicator will then light up when the Micron is activated and latch for approximately 20 seconds.
• Please ensure the rubber socket seals are properly in place when the sockets are not in use.

COMPATIBILITY (I-COM®)

The MX Micron contains an advanced transmitter device, capable of long distances, this is only compatible with the Fox MX receiver. Up to four MX Micron’s can be used at one time with the MX Receiver.

WORKS EXCLUSIVELY WITH THE MX RECEIVER NOT COMPATIBLE WITH EXISTING FOX RECEIVERS OR EXTENSION BOXE

WARNINGS

• DO NOT trigger LED or speaker in close proximity to human or animal eyes and ears.
• Store this equipment out of reach of children and infants.
• Avoid dropping or subjecting the Micron to severe impacts.

DRYING OUT AFTER USE IN HEAVY RAIN

These Microns have been designed to be weatherproof. However, after use in heavy rain, it is important to allow the unit to dry out properly by bringing the unit indoors and removing the hard case cover.

• NEVER place batteries in a hot environment (e.g. on a radiator).

BATTERY REQUIREMENTS

The Microns require 2 x LR03 AAA 1.5V Alkaline batteries. The use of good- quality batteries is essential for maximum battery life. To reduce the risk of battery leakage:

• DO NOT mix old and new batteries
• DO NOT mix different battery types
• The use of rechargeable batteries is NOT recommended

If the volume or LED performance noticeably decreases change the batteries. Please ensure the batteries are removed from the Micron during long periods without use.

CONTROLS

Turn the respective knob clockwise to increase the setting, and anti-clockwise to lower the setting. There are eight available.

Multi-colour LED control Simply pushes the rubber button to cycle through the LED colors on the MX heads. There is a choice of six colors: (Red, Green, Blue, Orange, Purple and White)

LOW BATTERY WARNING

When the MX Micron batteries are low the multi-colour LEDs will automatically change to the colour cyan (green-blue). They will remain this colour until new batteries are inserted into the alarm. Once new batteries have been placed into the MX Micron the LED colour will automatically revert back to your last chosen colour. No audible low battery warning is given by the MX Micron.

WARRANTY & PRODUCT REGISTRATION

FOX, I-Com and Micron are Registered Trade Marks. We reserve the right to alter or modify the contents of this manual. Hereby, Fox International Group Ltd declares that the radio equipment type Micron MX CEI198 is in compliance with the UK Radio Equipment Regulations 2017. The full text of the EU declaration of conformity is available at the following internet address: www.foxint.com/home/support/declarations-of- conformity/

Patents: EP1668983 Designed and Developed in the UK. ERP (effective radiated power) = -8 dBm max Operating frequency = 433.92MHz Ingress Protection Rating: IPX4

References

• Fox: Carp Fishing Tackle, Rods, Reels, Clothing And More
• Declarations of conformity
• Documents contractuels
• Declarations of conformity
• Documenti regolamento
• Keurmerken
• Dokumenty Regulaminowe
• Documente reglementare

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>