Woods 50016 Outdoor Digital Block Heater Timer User Manual
- May 21, 2024
- Woods
Table of Contents
Woods 50016 Outdoor Digital Block Heater Timer User Manual
Instructions
Plug the timer into the grounded outlet.
To Set the Current Time
Press the HOUR button as many times as necessary to advance the display to the correct time. Note, the time can only be set in 30-minute intervals. The LED display will display the hour (1-12) and on the half-hour, a light will illuminate in the upper right corner, next to the number 30. To change from AM to PM toggle 24 times, a dot will illuminate in the lower right corner of the display next to the letters PM.
To Program the Timer
Press the PROGRAM button once, and the letter P will flash. Press the HOUR button to set the ON time. Press the PROGRAM button again, the letter E will flash. Press the HOUR button to set the OFF time. Press the PROGRAM button to exit the program setting mode. Press the HOUR button to review the ON/OFF setting.
To Connect/Operate the Timer
Plug the device into the timer and turn the device on.
To Revise the ON/OFF Setting
Unplug the timer and plug it back in. Repeat the programming steps above.
To Override the Timer
Press the PROGRAM button if you want the device to turn on before the preset
time, but note the device will turn off at the preset time. For example, if
the preset ON/OFF period is 3 pm-4 pm, users can manually press PROGRAM to
turn the device on at 2 pm, and the timer will keep running until the preset-
off time at 4 pm. Suitable for use with outdoor appliances-raintight when
mounted vertically with the receptacle facing downward. Use a three-conductor
GFCI-protected outlet. Do not immerse in water. DO NOT EXCEED RATED CAPACITY.
Not for permanent installation. Do not install or use this product for more
than a 90-day period per year.
Download PDF:Woods 50016 Outdoor Digital Block Heater Timer User Manual