emotn DBRC-07 BLE and Infrared Remote Control User Manual
- October 30, 2023
- emotn
Table of Contents
BLE and Infrared remote control manual
DBRC-07 BLE and Infrared Remote Control
The remote control has two modes: infrared and bluetooth
- The indicator color of the remote control is Red
- When Bluetooth is not connected, the LED flashes once every time you press the button; For a long time, the LED still flickers once and then goes out;
- During Bluetooth pairing,LED flash slowly with a period of 500ms; If the connection is successful, steady on for about 3 seconds and then off
- When Bluetooth is connected, the LED does not blink when pressed
- Bluetooth pairing:Press the “right” and “Vol-” keys of the remote control at the same time, release when the LED blinks, the remote control will send the broadcast packet, and then operate on the host side for pairing.
- The name of Bluetooth device is Emton
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Statement :
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
IC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device
This device can be used without restricted.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>