NEXXT SOLUTIONS F3206-US 10A WiFi Smart Plug User Guide
- October 30, 2023
- Nexxt Solutions
Table of Contents
NEXXT SOLUTIONS F3206-US 10A WiFi Smart Plug User Guide
Install APP
2. Usage scenarios
3. Register APP
Configure
5. Experience
5. Experience
6. Parameters
Product: 10A Wi-Fi Smart Plug
Model: F3206-US
Rated Voltage: 100-240V~
Rated Current: 10A(Max.)
AC Frequency: 50/60Hz
Max.Load Power: 1100W
ON/Off Button
Press Long Time,Restore to Factory Settings
Series Connection are not allowed
Caution
- High Voltage – Disconnect power supply before servicing
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC ules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. RF Exposure: A
distance of 20cm shall be maintained between the antenna and users, and the
transmitter module may not be co-located with any other transmitter or
antenna.
Non-modification Statement:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
ISED Statement
This Class [B] digital apparatus complies with
Canadian CAN ICES-3(B).
Cet appareil numérique de la classe [B] est conforme à la norme NMB-3(B)du
Canada.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation,Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device. aux CNR d’Innovation, Sciences et
This equipment complies with ISED RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the radiator and any part of
your body.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une
distance de séparation d’au moins 20 cm doit être maintenue entre l’antenne de
cet appareil ettoutes les personnes.
CAN ICES-3 (B)/NMB-3(B)
Read More About This Manual & Download PDF: