HAFELE H238 Hand Dryer User Manual

HAFELE H238 Hand Dryer

Specifications

Warming

     Prohibited

|

• Do not let children hanging on the unit. Otherwise,this may be risk of falling.
• Do not open the front panel. Otherwise, it may cause electric shock risk.

warning
If you don’t use this unit properly or follow the safety guidelines carefully, it would lead to serious personal injury or property damage

---|---

Do not spray water

|

• Do not splash water. Otherwise, it may cause electric shock risk

Prohibit the use in bathrooms and showers

|

• Do not use in places where water is directly splashed or in places where it is prone to freezing. Otherwise, this may cause electric shock and unit malfunction.

Prohibit disassembling

|

• Do not reform and perform unnecessary disassembling. Otherwise, it may cause fire, electric shock and injury accidents.

Please follow with instruction

|

• Rated power is required. If power tolerance is over +/—10%, there will be breakdown.
• If using incorrect power supply, fire, electric shock and unit malfunction will happen.
• Please use dedicated socket.
• If used in combination with other appliances, it may cause abnormal heat in the shunt outlet.
• Power must be turn off during maintenance to prevent the risk of electric shock. Air filter must be installed.
• If the unit doesn’t work or have abnormal conditions, please turn off power to prevent accidents; and close leakage circuit breaker and ask supplier to check and repair, or it may lead to fire because of electricity leakage and shon circuit. **!** Unit must have reliable ground connection.
  **!** Attention when installation: Do not install when the unit are power connected

Warning

|

• This appliance is not intended for use by persons(including children) with reduced physical, sensory or mental capabiIities,or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• If the cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge it they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

|

• Environmental protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

Name of Each Part

Electrical Diagram

Precautions before Installation

Do not install in the following places (Otherwise may cause malfunction).

• Place with temperature below —10 °C or over 40 °C
• Place directly sprinkled by water
• Place with direct sunlight, strong light
• Place easy for condensation
• Place filled with corrosive, oxidizing and reducing gas
• Place with altitude over the range of 0 – 2000m

InstaIIation location

• The following picture shows the recommended location.
  (If there is floor or obstacles below the unit, the distance between unit and floor or obstacles should be at l east 400mm.)

• Keep the right side of unit away from mirror or wall, for the water droplets may splash out when you dry hands.
  (The distance should be 100mm above.)

• Please avoid the place easy to meet people and easy to encounter doors.

• Please select flat wall to install this product.
  

  • Power cord should be 1.0mm— 1.5mm

Install Method

1. Connect the line
   When installing unit without terminal box, you should install above the right side of unit with two—hole standard outlet corresponds to hand dryer. The distance should be 20—50cm.
   Please embed terminal box without cover in the installation location when directly connecting power cord is needed.
   Otherwise power cord will be forced out of body and can not be properly installed.
   

2. Fix the mounting plate
   Fix the mounting plate on wall with screws according to size.
   The unit provides a long power cord, please cut off the extra power cord as you need.
   Pull out power cord and connect it with power cord of unit.
   Wire connection must be based on the principle, that live wire connects with brown wire, null line connects with blue line, and individually wrappe with insulation tape to ensure no leakage.
   

3. Installation of body
   Visual orientation, and make main body hanging on the metal plate on wall
   

4. Fix the body
   ● Do as map indicated,press slightly on the body.
   ● And then pull out filter box,aiming at hole of insurance screw use cross screwdriver to turn on one screw at an angle of 45 degree, until the hand dryer is fixed firmly
   

Test Run

| Steps| Confirm information| Check & Notice
---|---|---|---
1| Shake the unit gently| The unit is installed firmly without shaking| It Will occur shaking and noisy when the unit doesn’t install firmly
2| Confirm the power and voltage| Please use the rated power supply| It will burn out unit or cause human accidents if the power use incorrect
3| Switch on the power| Close external power supply switch or insert the power plugs.| Power socket must be match the unit plug. Please check the power when the indicator light not bright
4| Put the power switch to[ON]| The power indicator light| Please check the power when the indicator light ont bright
5| Slid in your hands to drying| High speed wind blow out| Please confirm whether your

hands are far away from the sensor parts if there is no wind blowing out

6| Put the heating switch to[ONE| the high speed hot wind blow out| It Can change the hot and cold wind when the machine is working

Daily Use and Maintenance

External maintenance

Screw with a soft dry cloth or towel Sassafras. Please use neutral detergent.
Please don’t use organic solvents, acid or alkali toilet cleaner, cleaning brush etc.

Otherwise, the unit will destroy unit surface finish or produce discoloration.
If using a chemical cloth, make sure that the use of attention

Take out filter box Hold the raised part and pull down,then can easily take out it.

Remove the Alter From the filter box to filter out

Clean the air Alter.Blow or take off the dust of the air filter. Change when dust too much or filter for over 3 years

Prohibit washing Washing will damage the anti — bacterial components

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>