HAFELE 12V,24V Loox LED Driver Instruction Manual
- June 3, 2024
- HAFELE
Table of Contents
12V,24V Loox LED Driver
Instruction Manual
12V,24V Loox LED Driver
LED Drivers 12 V/24 V
WARNING
Read the instructions before assembly! Non-compliance with these instructions
can lead to electric shock, fire or injury. Likewise, read the instructions
for the LED lights and switches! Keep the instructions in a safe place and
give them to the user after assembly.
The controlgear is a Class II independent appliance, which does not rely upon
the luminaire enclosure for protection against accidental contact with live
parts. Constant voltage type controlgear.
Electrical safety
Never open or modify product components. Do not insert any foreign objects
into the openings of product components, as this could result in electric
shock or a short circuit Never expose the product components to moisture and
never assemble or store them near water or in damp, aggressive or potentially
explosive areas.
Never carry the product by the cable and do not use the cable to pull from the
socket. Never drill or damage the cable.
Keep product components away from heat, sharp edges or moving parts. Install
product components such that they cannot be accessed by children.
Intended use
The product is intended for:
- Assembly on/in furniture,
- Use in dry, interior spaces (Protection class: IP 20),
- TA Ambient temperature –20 to +45 ºC (-4 ºF to 113 ºF).
Ensure sufficient air circulation at the installation location.
Do not stack drivers.
Assembly
Check the scope of delivery before commencing assembly. If parts are missing
or damaged, contact the manufacturer. Never use and assemble damaged parts, or
small parts that are not part of the scope of delivery and not approved by
Häfele.
All product components must be assembled in a currentless condition. Switch
off the power supply [i] before commencing assembly.
Use suitable fixing material for the furniture [1].
Ensure that the total wattage of all connected LED lights and components does
not exceed the maximum output power of the driver (see type label) [2].
Cleaning and maintenance
Disconnect from the mains. Clean product components with a soft, dry and
fibre-free cloth. Do not use chemical cleaning agents, abrasive cleaners or
liquids!
The product does not contain any parts that should be repaired by the user. In
the event of a defect, replace the entire assembly.
Contact the manufacturer.
Disturbance
The lights connected to the driver flash:
- Ensure sufficient air circulation at the installation location.
- The wattage of the connected lights/devices exceeds the output power of the driver. Reduce the wattage of the connected lights devices.
Disposal:
Do not dispose with the household waste.
Observe country-specific regulations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>