MIBOXER FUT037 RGB LED Strip Controller Instruction Manual
- June 10, 2024
- MiBOXER
Table of Contents
MIBOXER FUT037 RGB LED Strip Controller Instruction Manual
Features
Product adopt the widely used 2.4GHz wireless technology with the features of low power consumption, long signal transmitting and strong anti-interference, etc. Widely used on the controlling of hotel lighting and home lighting.
RGB LED Light
16 Millions of colors to choose
Mix Red, Green and Blue light to adjust color temperature
Dim brightness / Saturation
2.4G RF wireless transmission technology
Remote control Control distance 30m
Smartphone app control (2.4GHz gateway is needed)
Support third party voice control (2.4GHz gateway is needed)
Dynamic mode table
Ml. Fade in adn fade out Here different colors fade into each other
M2. Strobe white Just white color flashes up
M3. RGBW fade in fade out This program fades in and fades out the color
red, green, blue and white one after another
M4. Color flash In this program, red, green, blue, white yellow purple
flashes to change
M5. Disco Different colors strobe and flash to change
M6. Red color ramp up and flash In this program, red color brightens from
0%-100% and shuts down, then flashes three times
M7. Green color ramp up and flash In this program, green color brightens
from 0%400% and shuts down, then flashes three times
M8. Blue color ramp up and flash In this program, blue color brightens
from 0%400% and shuts down, then flashes three times
M9. Color change+flash Here several colors fade into each other and then
flash randomly
Note: The colors can be dimming under any mode, the speed of any mode can be adjustable. For RGB LED strip light, the white is mixed from red, Green and blue, so the white is not pure.
Linking Code / Unlinking Code Instructions
Linking Code Instruction
-
Switch off light, after 10 seconds then switch on again.
-
Short press ” I ” button 3 times within 3 seconds when light on.
-
Lights blink 3 times slowly means linking is done successfully.
Linking failed if light is not blinking slowly, Please follow above steps again. • (Note: Light that have linked can’t link again)
-
Switch off light, after 10 seconds then switch on again.
-
Short press ” I ” button 5 times within 3 seconds when light on.
-
Lights blink 10 times slowly means linking is done successfully.
Linking failed if light is not blinking slowly, Please follow above steps again. • (Note: Light that have linked can’t link again)
Compatible with these remote controls (Purchased separately)
FUT089
FUT088
FUT092
FUT096
B8
B0
B3 / B3-B / T3
B4 / B4-B / T4
S2-B / S2-W S2-G
WL-Box1
Scan QR code to watch video instruction
Attention
- Please check whether the voltage of the power supply is in accordance with the light, and please check the connection of both the cathode and anode, otherwise the light will be broken.
- Please don’t connect wires with power on. Please turn on again only when it is in right connection and no short circuit.
- Non-professional user cannot dismantle the lighting fixtures directly.
- Please do not use the light in the place with widely range metal area or strong electromagnetic wave nearby, otherwise, the remote distance will be seriously affected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>