EXOR XA5 Outdoor HMI 5 Inch PCAP Touch Installation Guide
- June 11, 2024
- EXOR
Table of Contents
EXOR XA5 Outdoor HMI 5 Inch PCAP Touch
DIMENSION
PANEL MOUNTING
Fixing bracket
- A) XA5
- B) Cut-out on a flat surface (min wall thickness 1.2mm
4 pieces
Tightening torque: 130 Ncm ± 5 Ncm
ARM MOUNTING
AMPS Standard Fixing
CONNECTIONS
- CAN Port 0
- Power supply
- Ethernet Port 0 (10/100 Mb)
- USB Port V2.0 max 500 mA
- Ethernet Port 1 (10/100 Mb)
- CAN Port 1
- Expansion slot for plugin modules/
- LED
LED
POWER SUPPLY
- Extra low voltage power supply
- Don’t open the device rear cover when the power supply is applied.
24VDC supplied by SELV, limited energy source
Ensure that the power supply has enough power capacity for the operation of
the equipment
CAN PORT M12-5 A-coded
POWER SUPPLY M12-8 A-coded
USB PORT M12-USB type B-mini Female
ETH PORT M12-4 D coded
DISPOSE OF BATTERIES
Battery
These devices are equipped with rechargeable Lithium battery, not user-
replaceable
Dispose of batteries according to local regulations
AMBIENT LIGHT SENSOR
- A – Ambient light sensor
- B – User configurable LED
ANTENNA POSITION
The WiFi antenna is positioned behind the left side band, behind the display
The products have been designed for use in an industrial environment in compliance with the 2014/53/EU, 2011/65/EC directives
- EN 61000-6-4
- EN 61000-6-2
- ETSI EN 301 489-1 ETSI
- EN 301 489-17
- ETSI EN 300 328 EN 62311
- EN 61010-1
- EN 61010-2-201
The installation of these devices into the residential, commercial and light-
industrial environments is allowed only in the case that special measures are
taken in order to get the conformity to IEC61000-6-3.
Reproduction of the contents of this copyrighted document, in whole or part,
without written permission of Exor International S.p.A., is prohibited.
User Manual available on
www.exorint.com
MANXA5U001_V V.1.03 25.01.2023
©2022-2023 Exor International S.p.A Exor International S.p.A. – San Giovanni
Lupatoto VR, Italy
www.exorint.com