clarion CMM-10 Marine Source Unit with LCD Display Owner’s Manual
- June 11, 2024
- clarion
Table of Contents
CMM-10/CMM-10i
Marine Source Unit with LCD Display
OWNER’S MANUAL
![clarion CMM 10 Marine Source Unit with LCD Display - icon](https://manuals.plus/wp-content/uploads/2023/05/clarion-CMM-10-Marine-Source-Unit-with-LCD-Display-icon.png)
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must not accept any interference received,
including interference that may cause undesired operation. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, the user is
encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase separation between the equipment and the receiver.
– Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
-
* Only use this product in vehicles with 12 volt, negative-ground electrical systems. This product is not certified or approved for use in aircraft.
- Mount this product securely to prevent damage or injury in severe conditions.
- Do not replace the power wire fuse with one of a different value. Never bypass the fuse.
- Listen to your audio system at levels appropriate for operating conditions and hearing safety.
INSTALLATION CONSIDERATIONS
-
* Installation requires appropriate tools and safety equipment. Professional installation is recommended.
- This product is water-resistant. Do not submerge or subject to high-pressure water spray.
- Before installation, turn off the audio system and disconnect the battery system from the audio system.
- Install in a dry, well-ventilated location that does not interfere with your factory-installed systems. If a dry environment is not available, a location that is not exposed to heavy splashing may be used.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Carefully route all system wiring away moving parts and sharp edges; secure with cable ties or wire clamps and use grommets and loom where appropriate to protect from sharp edges.
GENERAL CONTROL FUNCTIONS
SPECIFICATIONS
RF exposure statement This equipment complies with the FCC RF radiation
exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20cm between the
radiator and any part of your body. This equipment meets the exemption from
the routine evaluation limits in section 2.5 of RSS-102. It should be
installed and operated with a minimum distance of 20cm between the radiator
and any part of your body.
IC WARNING This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
For the following equipment:
Product Name: Marine Source Unit
Brand Name: —
Model No.: CMM10GR
JL Audio, Inc.
E-mail: mphillipi@jlaudio.com
hereby declares that this [Name: Marine Source Unit, Model: CMM10GR] is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and Radio Equipment Regulations 2017 (SI 2017 No. 1206, as amended by SI 2019 No. 696).
This product is intended for sale and application in a business environment. RED Article 10 2 -This product can be used across EU member states
This product is intended for sale and application in a business environment.
RED Article 10 2
-This product can be used across EU member states RED Article 10 10
-The product is class 1 product, No restrictions
The RF distance between body and product is 0mm Bluetooth
Bluetooth Version:
Bluetooth V5.0(BR/EDR Mode)
Frequency Range:
2402MHz-2480MHz
Max.RF Output Power: 3.95dBm (EIRP)
AM
Frequency Range:
526.5-1606.5kHz Receiving
FM
Frequency Range:
87.5~108.0MHz Receiving
DAB
Frequency Range:
174-240MHz Receiving
©2023 Clarion Marine Audio
Printed in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>