clarion CMM-30 Marine Source Unit Owner’s Manual

: June 4, 2024
: clarion

Table of Contents

clarion CMM-30 Marine Source Unit Owner’s Manual
FCC COMPLIANCE STATEMENT
SAFETY CONSIDERATIONS
INSTALLATION CONSIDERATIONS
WHAT IS IN THE BOX
GENERAL MOUNTING
GENERAL CONNECTIONS
GENERAL CONTROL FUNCTIONS
AUXILIARY CONTROL OPTIONS
REMOTE
NMEA 2000®
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

clarion CMM-30 Marine Source Unit Owner’s Manual

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must not accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

SAFETY CONSIDERATIONS

Only use this product in vehicles with 12 volt, negative-ground electrical systems. This product is not certified or approved for use in aircraft.
Mount this product securely to prevent damage or injury in severe conditions.
Do not replace the power wire fuse with one of a different value. Never bypass the fuse.
Listen to your audio system at levels appropriate for operating conditions and hearing safety.

INSTALLATION CONSIDERATIONS

Installation requires appropriate tools and safety equipment. Professional installation is recommended.
This product is water-resistant. Do not submerge or subject to highpressure water spray.
Before installation, turn off the audio system and disconnect the battery system from the audio system.
Install in a dry, well-ventilated location that does not interfere with your factory-installed systems. If a dry environment is not available, a location that is not exposed to heavy splashing may be used.
Before cutting or drilling, check for potential obstacles behind mounting surfaces.
Carefully route all system wiring away moving parts and sharp edges; secure with cable ties or wire clamps and use grommets and loom where appropriate to protect from sharp edges.

WHAT IS IN THE BOX

GENERAL MOUNTING

GENERAL CONNECTIONS

GENERAL CONTROL FUNCTIONS

AUXILIARY CONTROL OPTIONS

Two connection t ypes are included for adding control capabi lities from auxiliary locations. Refer t o the suppl ied Owner’s Manual of each control ler/ type (sold separately) for specific user and instal lation instructions.

REMOTE

Connection Permit s d irect connection of wired controlle rs (sold separately) using accessory controller cable and splitters (sold separately).
Connect up to three contro llers to a single source unit, at up to 75 ft (23m) away (cumulative cable length). Each wired remote connect s d irectly using control ler cables and 2-way splitters (sold separately). Refer to the supplied Owner’s Manual for specific user and installation instructions.

CMR-20 Wired Remote Controller with LCD Display Full-function, water-resistant (I P67 rated) controller.

NMEA 2000®

Connection NMEA 2000®, Micro-C connector interfaces directly with NMEA 2000® net works using applicable
NMEA 2000® cab les and connectors (sold separately).

NMEA 2000® MFD Control Achieve control capabi lities from compatible multi- function displays
(MFD). NM EA 2000® functionality requires compatible NMEA 2000® entertainment protocols (PGN) and may require a software upgrade of connected M FD devices. Refer to
your M FD’s manufacturer for device compatibil ity info.