Clarion CMSP-101RGB Premium Marine Subwoofer Instruction Manual
- June 6, 2024
- clarion
Table of Contents
PREMIUM3
CMSP-101 RGB
One Premium 10 in / 250 mm Marine Subwoofer
with built-in RGB LED (2 & 4 ohm)
Ein 250 mm Premium Marine Subwoofer mit integrierter RGB-LED
Thank you for purchasing a Clarion Marine Subwoofer. With proper installation,
your new speakers will deliver years of listening pleasure.
We strongly recommend that you have your new marine speakers installed by your
authorized dealer. The installation professionals employed by your dealer have
the necessary tools and experience to properly install your new speakers. If
you prefer to perform your own installation, please read this instruction
manual completely before beginning the process.
Physical Specifications | CMSP-101 RGB-4 | CMSP-101RGB-2 |
---|---|---|
Nominal Diameter | 10.0 in. / 250 mm | 10.0 in./ 250 mm |
Outer Diameter (A) | 10.57 in. / 269 mm | 10.57 in. / 269 mm |
Bolt Hole Circle (B) | 9.72 in. / 247 mm | 9.72 in. / 247 mm |
Mounting Hole Diameter (C) | 8.75 in. / 222 mm | 8.75 in. / 222 mm |
Mounting Depth (D) | 5.16 in./ 131 mm | 5.16 in. / 131 mm |
Net Weight | 10.69 lbs/ 4.85 kg | 10.69 lbs/ 4.85 kg |
Driver Displacement | 0.074 ft3 / 2.10 litres | 0.074 ft3 / 2.10 litres |
NOTE: Subwoofer grille sold separately
Subwoofer Parameters | CMSP-101RGB-4 | CMSP-101RGB-2 |
---|---|---|
Free Air Resonance (Fs): | 47.15 Hz | 44.81 Hz |
Electrical “Q” (Qes): | 1.005 | 0.832 |
Mechanical “Q” (Qms): | 11.532 | 11.41 |
Total Speaker “Q” (Qts): | 0.925 | 0.775 |
Equivalent Compliance (Vas): | 0.88 ft3 / 24.93 litres | 0.87 ft3 I 24.77 litres |
One-way, Linear Excursion (Xmax)*: | 0.39 in / 10 mm | 0.39 in / 10 mm |
Efficiency (1W/1m)°: | 86dB SPL | 86 dB SPL |
Effective Piston Area (Sd): | 48.67 in2 / 0.0314 m2 | 48.67 in2 / 0.0314 m2 |
DC Resistance (Re): | 4.080 ohm | 2.180 ohms |
Nominal Impedance: | 4 ohm | 2 ohm |
Infinite Baffle Use: | Yes | Yes |
Power Handling (continuous): | 250W | 250W |
- Xmax specifications are derived via the one-way voice coil overhang method with no correction factors applied.
-
- Efficiency (1W/1m) is not an accurate indicator of a subwoofer’s output capability and should not be used as a comparison to other subwoofers to determine which one is “louder”!
Due to ongoing product development, all specifications are subject to change without notice.
SPEAKER CONNECTIONS
Terminal
|
Connection
---|---
| Speaker Positive (+)
–
| Speaker Positive (-)
RGB LED HARNESS WIRING
RGB LED Wire Color
| Wire size|
Connection
---|---|---
Red| 26AWG| Red LED Negative (-)
Green| Green LED Negative (-)
Blue| Blue LED Negative (-)
Yellow| Main LED Positive (+ 12V)
FIXED 7-COLOR LED WIRING
LED Color output
| LED Wire Color(s)|
Connection
---|---|---
Red| Red| Connect wire(s) to negative(-)
battery post or negative ground.
Green| Green
Blue| Blue
Yellow| Red+ Green
Pink| Red+ Blue
Light Blue| Green+ Blue
White| Red + Green + Blue
Connect all Yellow (+12V) LED wires to a switched +12V supply.
RGB LED SPECIFICATIONS
Specification | CMSP-101RGB |
---|---|
LED Current Draw at 14.4V DC | 220mA |
Recommended Fuse Value• | 250mA |
LED Voltage Range | 10- 14.4VDC |
• For short-circuit protection, install a fuse (not included) at each speaker’s Yellow (+ 12V) LED power connection lead.
WOOFER FEATURES
-
UV protected Injection molded polypropylene cone bodies with Santoprene rubber surrounds, specifically
formulated for marine duty -
Marine-grade, synthetic spider
-
Meets salt-fog and UV exposure standards (ASTM B117/D4329)
BUILT-IN RGB LIGHTING
- Multi-color LEDs, embedded and concealed from direct sight, produce lively accent lighting
Included Components and Parts:
- One Marine Subwoofer
- One 0.250-inch Female Crimpable Connector
- One 0.187-inch Female Crimpable Connector
- Six M5 x 35 mm Stainless-Steel Mounting Screws
- One Waterproof RGB LED Wire Harness
- Mounting Template
- Owner’s Manual
RGB LED Illumination:
LED functionality requires separate wiring at each speaker location. Choose
from seven fixed LED colors or connect an RGB lighting controller (sold
separately) for adjustable control.
BEFORE YOU BEGIN INSTALLING
- Check with your local waterway authority for any regulations regarding the use of accent/speaker lighting on your vessel.
- Turn off the audio system. It is also advisable to disconnect your battery system whenever performing installation work.
- Before cutting, drilling, or inserting any screw, check clearances on both sides of the planned mounting surface. Also check for any potential obstacles, such as wiring harnesses, fuel lines, hydraulic lines, etc. Check both sides of the vessel before cutting any holes.
- If you are running cables through bulkheads, drill holes for the cable and use a urethane or plastic grommet to protect the wire from chafing in the hole. Make sure that the cables will clear any mechanical devices in the boat and secure them with wire ties.
- Wear protective eyewear at all times and a dust mask and gloves when drilling or cutting.
CAUTION
When installing speakers in your vessel, it is extremely important to secure
them firmly. This applies not only to the speakers themselves but also to any
structure they are mounted to. If not firmly attached, the speakers can become
dangerous projectiles in a collision. Please review the mounting information
carefully and use the supplied marine-grade hardware to mount this product.
WARNING
While these speakers are designed to be water and spray-resistant, they are
not designed to be submerged or to
withstand high-pressure water spray. Do not install on submersibles, personal
watercraft, or any other vessel likely to be underwater at any time. Please
exercise care when washing your boat to avoid damaging your speaker. Avoid
contact with harsh chemicals or cleaning agents to prevent damage to the
speaker’s finish that will not be covered under warranty. Wash with mild soap
and rinse with fresh water only.
CAUTION
Prolonged exposure to sound pressure levels in excess of 100dB can cause
permanent hearing loss. This high-performance speaker can exceed this level.
Please exercise restraint in its operation in order to preserve your ability
to enjoy its fidelity.
WARNING
It is absolutely vital that your coaxial speaker system is connected as shown
in this manual. Failure to connect the system as shown will result in damage
to your speakers which is NOT covered under warranty. Do not substitute
different crossover networks.
LIMITED WARRANTY – MARINE SUBWOOFERS (USA)
Clarion Marine warrants this product to be free of defects in materials and
workmanship for a period of one (1) year from the original date of purchase.
This warranty is not transferable and applies only to the original purchaser
from an authorized Clarion Marine dealer. Should service be necessary under
this warranty for any reason due to manufacturing defect or malfunction,
Clarion Marine will (at its discretion), repair or replace the defective
product with the new or remanufactured product at no charge.
Damage caused by the following is not covered under warranty: accident,
misuse, abuse, product modification or neglect, failure to follow installation
instructions, unauthorized repair attempts, misrepresentations by the seller.
This warranty does not cover incidental or consequential damages and does not
cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to
accident or normal wear and tear is not covered under warranty.
Products installed as original equipment by boat manufacturers are covered by
the boat manufacturer’s warranty, not Clarion Marine.
Warranty is void if the product’s serial number has been removed or defaced.
Any applicable implied warranties are limited in duration to the period of the
express warranty as provided herein beginning with the date of the original
purchase at retail, and no warranties, whether express or implied, shall apply
to this product thereafter. Some states do not allow limitations on implied
warranties, therefore these exclusions may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights which vary
from state to state.
If you need service on your Clarion Marine product:
All warranty returns should be sent to Clarion Marine freight prepaid through
an authorized Clarion Marine dealer and must be accompanied by proof of
purchase (a copy of the original sales receipt.) Direct returns from consumers
or non-authorized dealers will be refused unless specifically authorized by
Clarion Marine with a valid return authorization number. Warranty expiration
on products returned without proof of purchase will be determined from the
manufacturing date code. Coverage may be invalidated as this date is previous
to the purchase date. Return only defective components. If one speaker fails
in a system, return only that speaker component, not the entire system. Non-
defective items received will be returned freight-collect. The customer is
responsible for shipping charges and insurance in sending the product to
Clarion Marine. Freight damage on returns is not covered under warranty.
For Service Information in the U.S.A. please call
Clarion Marine Customer Service: 1-800-GO-CLARION
(1-800-462-5274) 9:00 AM – 5:30 PM
(Eastern Time Zone)
Clarion Marine, a JL Audio Company
10369 North Commerce Pkwy.
Miramar, FL 33025
International Warranties:
Products purchased outside the United States of America are covered only by
that country’s distributor and not by Clarion Marine