LOREX L8559 Series 4K NVR and Battery-Operated Camera System User Guide

LOREX L8559 Series 4K NVR and Battery-Operated Camera System User Guide

What’s Included

• 4K NVR
  

• 4K Battery Camera (x4)
  

• 3-Cell Battery (x4)
  

• NVR Power Supply
  

• USB Mouse
  

• **Ethernet Cable

**

• HDMI Cable
  

• Camera Power Supply (x1)
  

• Mounting Anchors & Screws (x16)
  

• Security Screws (x4)
  

• Mounting Bracket (x4)
  

NVR Overview

FRONT

BACK

BOTTOM

1. Power Status Indicator
2. Status Indicator
3. HDMI Port
4. Ethernet Port
5. MicroSD slot
6. Power Port
7. USB Ports
8. QR Code

Camera Overview

**FRONT

SIDE

BOTTOM
**

1. Antenna
2. Warning Light
3. Light Sensor
4. Microphone
5. IR Light
6. Fastener
7. Adjustment Ring
8. Battery Release Tabs (x2)
9. PIR Sensor
10. Pairing Button
11. MicroSD slot
12. Speaker
13. Power Port
14. Locking Screw
15. Battery Charging Indicator
16. Mounting Plate Slots

Status Indicator

Power Status Indicator|

• Operating correctly

---|---
Status Indicator|

• Hard disk drive installed

Camera

Battery Charging Indicator

Battery Charging Time

3-cell Trois cellules / 3| Approx. 4-6 hours Entre 4 et 6 heures environ / Aprox. 4-6 horas
---|---

Camera Setup

The camera battery comes partially charged (due to safety regulations). Please, fully charge the battery before use and setup. You can charge the battery inside or outside of the camera.

1. Pull and remove the sticker on the camera battery.

2. Lift the Power Port cover, connect your camera to a micro-USB cord and adapter, and then connect to an outlet.
   

3. Insert the fully charged battery into the bottom of the camera.

Note: You will hear a ‘click’ when the battery is properly inserted. If you do not here a click, remove the battery by squeezing the release tabs, and then re-insert.

NVR Setup – Step

Connect the power supply: Connect the included NVR power supply to your recorder and a power outlet. Once your recorder has powered on, complete the Lorex Setup Wizard.

Step 3 (Optional)

Connect your mouse and display:

• Connect the included USB mouse to the USB port on your recorder.
• Connect your recorder to your display using the included HDMI cable. The HDMI supports up to 4K resolution.
  

Download the Lurex Cirrus App

To enable remote viewing with mobile apps, you will need to:

• Have high-speed Internet
• Have an upload and download speed of 10Mbps
• Find your recorder’s Device ID
  

1. Download

2. Tap .
3. Select your device from the Network list.
4. Follow the in-app instructions to complete the setup.

Note:

• Make sure you are on the same network as the NVR.
• If you cannot find your device on the network, input the default password: 00000000 and Media Port: 35000

Camera Pairing

1. If the camera cannot connect to the app or NVR, press and hold the pairing button until the red LED lights stop flashing, then release the pairing button.
2. From the NVR display or the Lorex Cirrus app, tap any free channel marked with a (display) or (app) icon.
3. Tap Pair.

Note:

• In the app, the message ‘Pairing success!’ will appear. If you do not see this message, repeat steps 1-3.
• On the NVR, you will have 30 seconds to pair the camera after you press and hold the pairing button on the back of the camera.

Need Help?

For the additional mounting and support material, scan the below QR code or visit:

help.lorex.com/L8559Series

Register Your Product

Please see our full Terms of Service and Limited Hardware Warranty Policy at:

lorex.com/warranty

The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Copyright © 2023 Lorex Technology Inc.
As our products are subject to continuous improvement, Lurex reserves the right to modify product design, specifications and prices, without notice and without incurring any obligation. E &OE. All rights reserved.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s) and Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC& IC Radiation Exposure Statement

This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

References

• Security Cameras - Home Security Camera Systems | Lorex

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>