HAFELE 833.95.012 24V LED Driver Constant Voltage User Guide
- June 11, 2024
- HAFELE
Table of Contents
833.95.012
833.95.022
Drivers constant Voltage
24 V
User Guide
833.95.012 24V LED Driver Constant Voltage
DANGER To reduce the risk of fire or electric shock, carefully follow
these instructions. Likewise, read the instructions for the LED lights and
switches!
Important safety instructions – save th ese instructions and give them to the
user after assembly.
The controlgear is a Class II independent appliance, which does not rely upon
the luminaire enclosure for protection against accidental contact with live
parts.
Constant voltage type control gear.
Electrical safety
Never open or modify product components. Do not insert any foreign objects
into the openings of product components, as this could result in electric
shock or a short circuit.
Never expose the product components to moisture and never assemble or store
them near water or in damp, aggressive or potentially explosive areas.
Never carry the product by the cable and do not use the cable to pull from the
socket.
Never drill or damage the cable.
Keep product components away from heat, sharp edges or moving parts.
Install product components such that they cannot be accessed by children.
Intended use
The product is intended for:
- Assembly on/in furniture,
- Use in dry, interior spaces (Protection class: IP 20),
- TA Ambient temperature –25 to +45 ºC (–13 to 113 ºF).
Ensure sufficient air circulation at the installation location.
Do not stack drivers.
Assembly
Check the scope of delivery before commencing assembly. If parts are missing
or damaged, contact the manufacturer. Never use and assemble damaged parts, or
small parts that are not part of the scope of delivery and not approved by
Häfele.
All product components must be assembled in a currentless condition. Switch
off the power supply [i] before commencing assembly.
Use suitable fixing material for the furniture [1].
Ensure that the total wattage of all connected LED lights and components does
not exceed the maximum output power of the driver (see type label) [2].
Cleaning and maintenance
Disconnect from the mains. Clean product components with a soft, dry and
fibre-free cloth. Do not use chemical cleaning agents, abrasive cleaners or
liquids!
The product does not contain any parts that should be repaired by the user. In
the event of a defect, replace the entire assembly.
Contact the manufacturer.
Disturbance
The lights connected to the driver flash:
- Ensure sufficient air circulation at the installation location.
- The wattage of the connected lights/devices exceeds the output power of the driver. Reduce the wattage of the connected lights devices.
Disposal:
**** Do not dispose with the household waste.
Observe country-specific regulations.
© 2022 by Häfele SE & Co KG
Adolf-Häfele-Str. 1 · D-72202 Nagold ·
www.hafele.comhttps://www.haefele.de/en/power-
supply