HONG KONG CW3-22001 Bluetooth Sunglasses User Manual
- June 9, 2024
- HONG KONG
Table of Contents
HONG KONG CW3-22001 Bluetooth Sunglasses
OVERVIEW
PRODUCT SPECIFICATION
OPERATIONAL INSTRUCTIONS
Power On/OFF:
- Long Press the “M” button 2 seconds tum on, blue LED flashes.
- Long Press the “M” button 2 seconds tum off.
Pairing with Smart Phones
- Automic enters pairing mode after power on (red and blue lights flash alternately), search SM2 for pairing on a bluetooth device After connecting the blue light flashes every 3 seconds when disconnected it will back to paring mode. when powered on it will automatically connect to the last
- Bluetooth device. automatically tum off when there is no Bluetooth connection in 5 minutes.
Audio mode:
- One tap of the “V” button to volume up, prompts the sound in maximum volume Long
- Press the “V” button to volume down
- Tap the “M” button to play/pause
Call mode:
- One tap “M” to answer a phone call
- One tap “V” to Reject a phone call
- One tap “M” to hang up
Charging mode:
- Charging time is about 1.5 hours, battery low alarm with a voice prompt “battery low”.
- The low battery alarm interval is 60 seconds.
- The red light flashes twice. The red LED is on when charging. The blue LED is on when fully charged. Can’t power on while charging.
FCC
Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connecting the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for helps.
The device has been evaluated to meet the general RF exposure requirement
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>