Sertus Hong Kong W40239 Tetrix 2.4 GHz 4-Channel Wireless Gamepad User Manual
- June 5, 2024
- Sertus Hong Kong
Table of Contents
Sertus Hong Kong
W40239 Tetrix 2.4 GHz 4-Channel Wireless Gamepad
User Manual
Products information
Product Model Number: 40239
Product description: TETRIX 2.4 GHZ 4 CHANNEL
WIRELESS GAMEPAD
Trade Mark : Tetrix
Product manufacturer: RC Leading Toys Factory
The main parameters
- Working frequency：2412 MHz ~2472MHz
- modulation method: GFSK
- TX antenna: built-in
- transmission Conducted power: -0.092 dBm
- TX Gain: 0dBi
- voltage TX: 6V (AA×4s)
- current TX: 210mA±10%（6V）
- RX sensitivity: ‐12dBm
- RX antenna: built in
- RX operating voltage: 6V
- RX working current: 22mA±10%（6V）
- The RX weight: 5.5g±10%
- Control distance: 100～120M（RX from the ground
The function of TX（see below）
Binding mode
- ensure that the RX was turned off ；
- Turn on the TX, and press the “connect button” for 2 seconds, until the green LED light start to flash.
- RX insert the battery pack, the red LED lights to start flashing, press the “connect button” 22 seconds, until the red LED to rapid flashing, now the TX and received start binding
- Once the TX and RX stop flashing and turn to light, it means binding success
Other instructions
- TX low voltage alarm function: when the TX battery voltage is lowered to 4.1 V, the TX buzzer begins to make a noise, and at the same time, the LED gets flashing, indicating the user to replace the batteries immediately.
- Please put on the battery as the mark, otherwise it will not work
- Take out the battery from TX when you don’t use it, to avoid battery leakage and damage to TX components
- Connect the servos and battery to the RX, please pay attention to the channel position, otherwise can not be controlled.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>