LOREX LNZ81P25 Series 4K PTZ IP Camera User Guide
- June 9, 2024
- Lorex
Table of Contents
Quick Start Guide
4K PTZ IP PoE Camera
lorex.com
Safety Precautions
- Make sure to disconnect the power cabling before installing the camera. Camera will begin moving immediately when power cable is connected.
- Make sure to install the camera in a location that can support the combined weight of the camera and wall mount (weight: 11.7lb/5.3kg).
- Make sure to secure the camera during installation by connecting the included safety chain.
- Camera is rated for outdoor use. It is recommended to install the camera in a sheltered area, such as under the eaves on a roof.
- It is recommended to install the camera as high up as possible to get the best possible image.
- Mount the camera where the lens is away from direct and intense sunlight.
- Mount the camera in an area that is visible but out of reach.
- Ensure that the camera wiring is not exposed or easily cut.
- Plan your cable wiring so that it does not interfere with power lines or telephone lines.
- Ensure you adhere to local building codes.
Attention
A REGULATED UL / CSA APPROVED power supply is REQUIRED for use with this
camera (included). Use of a non-regulated, non-conforming power supply can
damage this product and voids the warranty.
Package Contents
Tools Needed
- Drill
- Screwdriver
Overview
WARNING
Make sure to install the camera in a location that can support the combined
weight of the camera and wall mount.
Installation
-
Attach the rubber ring to the back of the wall mount.
-
Use the Allen key (A) with the flat end to attach three M6x14 screws. Do not tighten all the way.
-
Use the wall mount to mark holes for the mounting anchors and cables.
-
Drill holes (drill bit size – 3/8”) to a depth of 2.8”/70mm in the mounting surface.
-
Insert the mounting anchors.
-
Connect the safety chain between the camera and the wall mount to protect the camera from falling while connecting the cables.
**** Do not hold the camera from the cable. Hold the camera from the edge of the dome cover.
-
Push the connection cables into the wall mount.
-
Push the camera into the wall mount with the flat surfaces aligned on the inside. This will allow the M6x14 screws to align with the holes on the camera.
-
Use the included Allen key (A) to tighten the M6x14 screws and secure the camera in.
-
Connect the connection cables.
Wiring
To connect the cables using the waterproof connector: 
a. Fit the o-ring around
the camera Ethernet connector.
b. Feed the Ethernet extension cable through the end cap and the barrel then
connect the cable to the camera Ethernet connector.
c. Twist the barrel securely onto the camera Ethernet connector. The o-ring
becomes compressed when the seal is properly tight.
d. Split the stopper to wrap it around the cable between the barrel and end
cap as shown above.
e. Push the stopper toward the barrel until it is underneath the teeth at the
end of the barrel.
f. Twist the end cap clockwise to secure it onto the barrel. The stopper
becomes compressed and will stick out of the end cap slightly when the seal is
properly tight.
Tip!
For full instructions on controlling the PTZ camera with the NVR, refer to the
PTZ camera’s manual at:
help.lorex.com/LNZ81P25Series
-
Pull the connection cables through the wall mount and mounting surface.
-
Use the Torx key (B), mounting screws, and flat washers (x4) to firmly secure the wall mount to the mounting surface.
Note
If mounting the camera on a drywall surface, you must drill at least 2 of the mounting screws through a wooden stud to ensure a stable mount. -
Remove the protective vinyl sheet covering the camera lens.
Need Help?
For up-to-date information and resources, scan the QR code or
visit:help.lorex.com/LNZ81P25Series
- Download product guides
- Find related troubleshooting tips & FAQs
Register Your Product
Please see our full Terms of Service and Limited Hardware Warranty Policy at:
lorex.com/warranty
Copyright © 2022 Lorex Technology Inc.
As our products are subject to continuous improvement, Lorex reserves the
right to modify
product design, specifications and prices, without notice and without
incurring any obligation.
E&OE. All rights reserved.
LNZ81P25_QSG_TRILINGUAL_R1
References
- LNZ81P25 Series - Lorex 4K Ultra HD 25x Pan-Tilt-Zoom IP Camera | LOREX Support
- Security Cameras - Home Security Camera Systems | Lorex
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>