Victrola VSC-750SB-YEL Revolution GO Portable Record Player User Manual
- June 9, 2024
- Victrola
Table of Contents
VSC-750SB-YEL Revolution GO Portable Record Player
User Manual
FAQ
How long do needles typically last?| The stylus should last about 50 hours
under normal use.
---|---
What is the best way to store the unit?| Keep record players in clean, dry
locations. Keep all accessories with your unit such as the manual, power
adapters, needles, etc. Do not stock anything on top of your vinyl OR record
players.
How should I clean my unit?| Remove dust with a clean lint-free cloth semi-
regularly. In order to clean the unit, we recommend a slightly moistened towel
to remove build up as well as a dry cloth to remove any extra moisture.
How are record players packaged when shipped?| Packages are double boxed and
sealed with packing tape to assure that your item will not move around or
become damaged during the shipping process. Please be aware to unscrew the
safety screw that holds down the platter so it will not be damaged in
shipping.
Speaker Connection|
Can I wirelessley stream music to my record
player from a Bluetooth device?| Yes, you can pair a Bluetooth enabled device
to play through the internal
speakers.
Can I wirelessley connect external speaker to my record player through
Bluetooth?| No, for these models the Bluetooth function is only used to stream
music from a Bluetooth enables device to the internal speakers on the record
player.
---|---
How do I
connect a wired
speaker to my
device?| If applicable with your model, a wired speaker can be connected via
RCA cable. For Amplifier device with this input, insert the white and red
plugs on the RCA cable into the unit. Insert the opposite end into the
amplifier device. Be sure to connect the white plug to white jack and the red
plug to the red jack or this connection will not work.
Set up|
How do I play
45s on my
record player?| First, take the 45 adaptor and place it over the center of the
turntable. Then, change the speed to 45 on the speed selector located to the
right of the tone arm. You can now play your favorite 45’s!
How do I set up
my record
player?| Start by unboxing your record player and making sure you have
received all the correct pieces. Make sure to find a straight, level area to
place your record player as any slanted surface can cause an issue with the
player skipping. Plug in the power cord to the appropriate power supply and
into the back of the player. If your records are not playing properly or the
turntable is not spinning, then please try adjusting the screw on the back of
the turntable by turning it a quarter of a turn each time and then try
playing a record.
How do I install a replacement needle?| Removing the Stylus from the Cartridge
1. Set a screwdriver at the tip of the stylus and push down gently. WARNING:
When applying force to the stylus, too much may damage the stylus.
2. Pull the stylus out in a slightly downward direction. Installing the
Stylus
1. Hold the tip of the stylus and insert the other edge in an upwards
direction.
2. Push the stylus up until it locks it at the tip.
TROUBLESHOOTING
Why is my turntable humming?| Please make sure your power cord is fully
plugged into the unit and the outlet. Then, be sure the unit it away from
other electronic devices that may cause interference.
---|---
Why is the platter wobbly?| The turntable platter is built on top of springs
and it is not designed to fit firmly in place on top of the wood. This design
allows the record player to turn smoothly without grazing against the wood.
How do I reset/reboot my unit?| In order to reboot just unplug the unit from
the wall outlet and then let the unit rest for about 6-8 hours.
My drive belt or motor stopped working| Please contact
support@victrola.com for assistance.
| There is a screw at the back of the turntable that balances the turntable
and the tonearm weight if the records do not play properly or if the
turntable does not spin. This is the only adjustment available on the unit.
If your records are not playing properly or the turntable is not spinning then
please try
---|---
My record player is playing
too fast or too slow| adjusting that screw by turning it a quarter of a turn
each time and then try playing a record. If it does not sound properly then
keep the arm back in the rest position and then again adjust the screw by a
quarter of a turn.
| Then try playing the record again. Do this process till you get your records
playing perfectly.
| Please refer to our manual repository located on our
I lost my manual| site: https://victrola.com/pages/owners-manuals
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>