AENO AEG0002 EG2 Electric Grill User Manual

June 9, 2024
AENO

aeno-logoAENO AEG0002 EG2 Electric Grill

AENO AEG0002 EG2 Electric Grill-product

Product Information

The AENO EG2, EG2-UK Electric Grill is designed to cook various meat and fish dishes. It comes with heating plates, a plastic drip tray, and a cable for the power supply. The grill has a maximum power of 1800W and a voltage of 105V. It is advised to contact the online support team or service center for any issues or questions related to the product.

Product Usage Instructions

  1. Unpack the grill and reel out its cable, but do not plug it into the mains socket.
  2. Make sure that heating plates (4) are clean and free of dust. Wipe them with a damp cloth if necessary.
  3. Install the plastic drip tray (6) at the back of the grill.
  4. Place the grill on a flat and stable surface.
  5. Plug in the cable to the main socket.
  6. Turn on the grill and wait for it to heat up for about ten (10) minutes.
  7. Cook your desired meat or fish dish on the heating plates (4).
  8. When finished, turn off the grill and unplug it from the main socket.
  9. Clean the heating plates (4) and drip tray (6) with a damp cloth.

Troubleshooting

If the grill does not turn on, make sure that it is properly plugged in. If the problem persists, contact your local supplier or the service center for support. Do not disassemble or attempt to repair the device on your own.

AENO EG2, EG2-UK Electric Grill is designed to cook various meat and fish dishes.

Specifications

Supply voltage: AC220–240V, 50/60Hz, Power: 2000.0 W. Cooking surface area: 290mm × 233mm. Opening angle: 105° and 180°. Stainless steel casing. Cable length: 0.8 m.

Package Contents

AENO EG2, EG2-UK Electric Grill, drip tray, quick start guide, warranty card.

Limitations and Warnings

Children and people with disabilities may only use the grill under the supervision of adults or people with an adequate level of experience in using the device. Keep the grill out of the reach of children. The grill’s surface becomes very hot during operation, and food products may emit steam or splashes of oil. Do not touch the grill’s casing with hands; use heat–protective gloves when operating the grill. Do not use the grill outdoors, and keep it away from sources of heat, direct sunlight, open fire or high humidity, as well as never operate it with wet hands. Always unplug the grill when it’s not used for cooking. Do not immerse the device in water or other liquids. Never use the grill if it’s damaged or its power cord is broken. Do not try to repair the device on your own. Always install the grill on a flat and stable heat–resistant surface in a well–ventilated area. If the grill contains too many food products at once, so it can hardly be closed, never use force to close it as you may damage the device. To avoid fire hazard, never leave the switched–on device unattended. The grill must be closed before connecting it to the mains. After cooking, the cooked food shall be removed from the grill using wooden or heat–resistant spatula only. Do not use a sharp fork or knife to remove food products from the grill as this may damage its non–stick coating. Frozen food products shall be completely defrosted before grilling.

Initial Setup

Unpack the grill and reel out its cable, but do not plug it into the mains socket. Make sure that heating plates (4) ( See Figure b) are clean and free of dust. Wipe them with a damp cloth if necessary. Make sure that the plastic drip tray (6) is installed at the back of the grill (See Figure c). Place the grill on a flat and stable surface. Plug the power cord into the mains socket – the white Power LED will flash (See Figure a).AENO
AEG0002 EG2 Electric Grill-fig-1 Then, turn the temperature control knob (1) from “0” to the MAX position in order to start preheating the cooking surface. The blue automatic temperature control LED (3) will flash. As soon as the cooking surface temperature reaches the set value (This usually takes about 3–5 minutes), the blue LED (3) will go out. This means the grill is ready for operation. If used for the first time, the device shall be heated up without food products for about ten (10) minutes. A small amount of light smoke or odor is deemed to be normal and harmless.

Operation

Open the upper grill cover and place the food products on the lower cooking surface. Close the upper grill cover – the blue LED (3) will flash. During operation, the white power LED (2) will be on all the time, while the blue LED (3) will be on for periods of additional heating up when the temperature of the cooking surfaces decreases, and will go off when the cooking surfaces temperature reaches the value set with the temperature control knob (1).

Cooking time may take 5 to 8 minutes depending on the type of food product, its thickness or the desired degree of doneness. Excess oil or grease will be drained through the drain hole (5) into the drip tray (6).
If the food product is recognized as being well cooked, open the grill after the blue LED goes out only, because it will be switched off at that moment. After cooking is done, turn the temperature control knob (1) to the “0” position, unplug the grill and open the top cover to cool down the device.

Troubleshooting

  1. The grill does not turn on. Possible causes and solutions: Make sure that there is no power supply failure in the mains socket (e.g. plug any known good device into it) and that the grill is correctly plugged into the mains socket.
  2. The grill turns on but does not heat up. Possible causes and solutions: Make sure that the temperature control knob (1) is not set to the “0” position.
  3. Blue LED (3) does not flash. Possible causes and solutions: Unplug the grill, let it cool down and plug it back in the mains socket. Then, turn the temperature control knob (1) to another position.

ATTENTION! If your problem persists, please contact your local supplier or the service center for support. Please do not disassemble the device or try to repair it on your own.

If you have any questions or issues with your AENO device, please contact our online support team support@aeno.com or aeno.com/service-and-warranty. This is a better option than visiting the store and will save you time and effort.

Please contact our online support team if you have any questions or issues with your AENO device.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals