PHILIPS PSE0500 Smart Meeting Microphone User Manual
- June 5, 2024
- Philips
Table of Contents
PHILIPS PSE0500 Smart Meeting Microphone
Computer connection by USB
- Use the attached special charger to energize the PSE-0500;
- Use the attached special USB cable to connect the PSE-0500 to the computer
The system will load the driver automatically. After loading is completed, an audio device will appear in the system’s device manager, as shown below
This means that the set-up is successful, and the PSE-0500 can be used normally. If the computer is connected to many external devices, the input device should be set to the PSE-0500 in the system’s audio settings, as shown below
The Windows 7 system or above is recommended. An older system may require the setup of the USB universal driver and has poor compatibility, thereby affecting the performance of the PSE-0500.
Bluetooth connection mode
- When the PSE0500 is connected to the computer via USB, the Bluetooth function will be turned off and the Bluetooth indicator light will be off;
- Use the attached special charger to energize the PSE-0500；
- When the Bluetooth indicator of the PSE-0500 flashes, search for and pair the PSE-0500to another device through Bluetooth, then the PSE-0500 can be used.
If the computer is connected to many external devices, the input device should be set to the PSE-0500, and the output device to the PSE-0500 in the system’s audio settings, as shown below
Volume control
Press the V+/V- keys for volume control.
4 On/off
When this device is off, press the power key to turn it on; when this device is on, press the power key to turn it off.
5 Mute
When the mute function is off, press the key in the front of the PSE-0500 to start the mute function, the thePSE-0500 will not output the audio to the other device, and the red indicator will be illuminated, indicating the mute state, indicating the mute state;
When the mute function is on, press the key in the front of the PSE-0500 to close the mute function, then the PSE-0500 will output the audio to the other device, and the red indicator will go out, and the blue indicator will be illuminated.
If the PSE-0500 is to be paired to any other device when being connected to the computer through Bluetooth, hold down the Bluetooth key, then the PSE0500 will be in the pairing state and can be searched for and paired again, or you can cancel the pairing of the device in use, the PSE-0500 can be searched for and paired again.
- A PSE-0500 supports up to four PSE-0400s by wired or wireless connection.
- Refer to the operation manual for the specific operation of the PSE-0400.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>