VOLTCRAFT VC-PD40W-2C 2x USB-C Vehicle Charger Instruction Manual

VOLTCRAFT VC-PD40W-2C 2x USB-C Vehicle Charger

Product Information

The product is a USB charger designed to be used in a vehicle. It automatically detects the best charging mode and starts charging after connection. The charger has safety instructions and warnings that must be observed to prevent personal injury or damage to property. The latest product information can be downloaded from the manufacturer’s website.

Product Usage Instructions

1. Read the operating instructions carefully and observe the safety information.
2. Ensure that the vehicle engine is started before connecting the USB charger to prevent discharging of the vehicle battery.
3. Do not short-circuit the USB port terminals.
4. Do not connect products that exceed the rated output current of the charger.
5. Disconnect the product from the vehicle auxiliary power outlet (cigarette lighter) when not in use.
6. Handle the product carefully to prevent damage from jolts, impacts, or falls.
7. Do not place the product under any mechanical stress and protect it from extreme temperatures, flammable gases, steam, solvents, high humidity, moisture, and direct sunlight.
8. Consult an expert when in doubt about the operation, safety, or connection of the product.
9. Always observe the safety and operating instructions of any other devices connected to the product.
10. Maintenance, modifications, and repairs must only be completed by a technician or an authorized repair center.
11. For cleaning and care, refer to the manufacturer’s instructions.
12. Dispose of the product according to local regulations.

Intended use

The product is a USB-C® charger that connects to a vehicle auxiliary power outlet (cigarette lighter socket).
The product is intended for indoor use only. Do not use it outdoors.
Contact with moisture must be avoided under all circumstances.
If you use the product for purposes other than those described, the product may be damaged. Improper use can result in short circuits, fires, electric shocks or other hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the product.
Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.
All company names and product names are trademarks of their respective owners. All rights reserved. USB4®, USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.

Delivery contents

• Product
• Operating instructions

Latest product information
Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Fol-low the instructions on the website.

Description of symbols

The symbol warns of hazards that can lead to personal injury.

Safety instructions

Read the operating instructions carefully and especially observe the safety informa-tion. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

General

• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing materials for children.
• If you have questions that remain unanswered by this information product, contact our technical support service or other technical personnel.
• Maintenance, modifications and repairs must only be completed by a technician or an authorized repair center.

Handling

• Handle the product carefully. Jolts impacts or a fall even from a low height can damage the product.

Operating environment

• Do not place the product under any mechanical stress.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
• Protect the product from high humidity and moisture.
• Protect the product from direct sunlight.

Operation

• Consult an expert when in doubt about the operation, safety or connection of the product.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe operation can no longer be guar-anteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to any serious transport-related stresses.

Connected devices

• Also, observe the safety and operating instructions of any other devices which are connected to the product.

Product

• Do not short-circuit the USB port terminals.
• Do not connect products that exceed the rated output current of the charger.
• Always start the vehicle engine before connecting the USB charger.
• Disconnect the product from the vehicle auxiliary power outlet (cigarette lighter) when not in use.

Operation

Important:
The vehicle battery will discharge if the charger is used when the vehicle engine is switched off.
The product will automatically detect the best charging mode and start charging after connection.

Cleaning and care

Important:

• Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
• Do not immerse the product in water.

1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.

Disposal

This symbol must appear on any electrical and electronic equipment placed on the EU mar-ket. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.

Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-de-structive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.

Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.

Technical data

Input . ……………………………………………… 12 – 24 V/DC, 4 A max.
Output …………………………………………….. 2 x (USB-C® 20 W):
5 V/DC 3 A, 9 V/DC 2.22 A, 12 V/DC 1.67 A
Total output power ……………………………. max. 40 W
Power deliver y…………………………………. support PD 3.0
Protection ……………………………………….. Short circuit, overload
Fuse ……………………………………………….. 7 A / 32 V (built-in, non-replaceable)
Operating conditions. ………………………… 0 to +35 °C, 10 to 95 % RH
Storage conditions ……………………………. -10 to +55 °C, 5 to 95 % RH
Dimensions (L x ø) …………………………… 70 x 28 mm
Weight ……………………………………………. 36 g

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.

References

• Conrad Electronic » All parts of success
• Download center

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>