SoundCore Flare 2 Portable Speaker A3165 User Manual
- June 13, 2024
- Soundcore
Table of Contents
SoundCore Flare 2 Portable Speaker A3165
USER MANUAL
At a Glance
1. Light mode button
2. Power button
3. Volume buttons ( – / +)
4. Multi-function button
5. Bass Boost button
6. Bluetooth & PartyCast button
7. USB-C charging port
Charging
- Use the included USB cable to charge your speaker and make sure it is fully charged before the first use.
- Do not charge your speaker for extended periods.
- When not in use, store your speaker in a cool place.
Powering On/Off
Bluetooth Pairing
- When powered on, the speaker will automatically connect to the last connected device if available within the Bluetooth range. If not, press the Bluetooth button to enter the Bluetooth pairing mode.
- To pair with another device, press the Bluetooth button to re-enter the pairing mode.
PartyCast Mode
Set up one Flare 2 as the primary speaker and connect it with more than 100+ secondary Flare 2 speakers to control audio and all the light modes.
Set up the primary speaker:
1. Connect one Flare 2 speaker to your phone or other devices via Bluetooth.
When successfully connected, the Bluetooth LED will turn blue.
2. Press and hold the Bluetooth button on this Flare 2 for 3 seconds until
you hear a sound and the Bluetooth LED flashes white to indicate this Flare 2
is the primary speaker.
- The Bluetooth LED on the primary speaker will keep flashing white.
Connect with secondary speakers:
1. Make sure the secondary speakers aren’t connected to any Bluetooth devices.
- Press the Bluetooth button to disconnect Flare 2 from a device, the Bluetooth LED will flash blue.
2. Press the Bluetooth button for 3 seconds until you hear a sound and the
Bluetooth LED flashes white to indicate the secondary speaker is in connection
mode.
3. When successfully connected, the Bluetooth LED on the primary speaker will
continue flashing white, while on the secondary speakers will turn white.
When PartyCast mode is successfully entered:
- You can power off, adjust the volume, or switch light modes for all speakers by controlling the primary speaker only;
- You can power off or switch light modes for each secondary speaker individually;
- You can’t adjust the volume for each secondary speaker individually;
- To exit the PartyCast mode, press the Bluetooth button on either speaker for 3 seconds until the Bluetooth LED flashes blue.
Button Controls
Light Modes
Download the Soundcore App to check all available light modes.
Light Modes
Download the Soundcore App to check all available light modes
Soundcore App
Download the Soundcore App for light modes, EQ settings, firmware updates and more.
Specifications
| Input | 5 V 2 A |
|---|---|
| Rated output power | 2 x 10 W |
| Battery capacity | 2600 mAh, 7.4 V |
| Charging time | 3.5 hours |
| Playtime (varies by volume level and content) | 12 hours |
| Frequency response | 50 Hz – 20 kHz |
| Bluetooth version | V 5.0 |
| Bluetooth range | 20 m / 66 ft |
Support Videos
How to pair two Flare 2 Speaker
How to pair Soundcore 3, Mini 3, and Flare 2 Speakers via PartyCast
How to pair Motion Boom Plus with Flare 2
How to pair Rave Neo 2 and Flare 2 Speakers via PartyCast
DOWNLOAD
SoundCore Flare 2 Portable Speaker A3165 User Manual – [Download PDF]
SoundCore Flare 2 Portable Speaker A3165 QSG- [Download PDF]
A3165 Soundcore Flare 2 Declaration of Conformity – [Downoad PDF]