WALLYS DR6018-S High Power Radio AP Router User Manual
- June 9, 2024
- WALLYS
Table of Contents
DR6018-S High Power Radio AP Router
User Manual
DR6018-S High Power Radio AP Router
THIS DOCUMENT CONTAINS PROPRIETARY TECHNICAL INFORMATION, WHICH IS THE PROPERTY OF THE WALLYSTECH AND SHALL NOT BE DISCLOSED TO OTHERS IN WHOLE OR IN PART, REPRODUCED, COPIED, OR USED AS THE BASIS FOR DESIGN, MANUFACTURING, OR SALE OF APPARATUS WITHOUT WRITTEN PERMISSION OF WALLYSTECH.
- Input the IP 192.168.1.1 and login
- Input the username “admin” password “password” then press the button “Login”
Network setting
- IP Setting: setting IP in the path “network->Interfaces->LAN>IPV4 address”
- DHCP setting:DHCP and other protocol setting in the path network-> Interfaces-> LAN->protocol”
Wireless setting
Login the path network->Interfaces->WIFI,
Then choose WiFi 1,we select the red marked as example, click the button “
Edit ”
IPQ601x UI setting
The detail information show in the picture as below:
- Channel: for channel select;
- Transmit Power: signal chain power setting; ESSID: for ID
- Mode: it support 4 mode AP,AP(WDS),client, client(WDS) Wireless
- Security: for Encryption setting
IPQ601x UI setting
In advance setting you can select which chain do you need, which BW do you
need and so on
In the end, you need click the button “Save & Apply”, and wait for 2 minutes, then you can enjoy it.
Backup archive
Login System->Backup/Flash Firmware;
Then click the button “Generate archive”
Then download the archive
Update new image
Login System->Backup/Flash Firmware;
Then click the button “ flash image”
Then click the button “Proceed” warning don’t power off wait for about three
minutes Then the system will reboot automatic.
Then login again, you can enjoy it.
wireless encryption
Login System->Network/WiFi/Edit->Choose 5G radio
Country Coad choose “ US ” click the button “Wireless Security”
Then choose “WPA3” and set password
Notice: SAE/SAE PWE/SAE MFP click “ √ ”
Introduction
The photo below shows how to use the Uart for DR6018-S
Device connect
Step 1:Connect the cable to the DR6018-S
As the picture as above, the sequence of the signal in the UART
Connector: GND,TX,RX,VCC, And we need use GND connect black cable, TX connect
to white cable, RX connect to Green cable VCC don’t use.
Step 2: Check the Com number on the PC Connect the console board to the PC
with USB connector, Then check the com number on the PC, the com number on the
test PC is COM9
Step 3 Login with the software You can use putty, Shall or some others, enjoy it.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>