Darkglass Enhancer Series Hyper Luminal User Guide
- September 12, 2024
- DARKGLASS
Table of Contents
Darkglass Enhancer Series Hyper Luminal
Specifications
-
Controls:
Hyper Luminal Manual Enhancer Series -
Blend
Mixes the clean and effected signals. Unlike our distortions, it is placed before the Output control. So the Hyper Luminal can also be used as a transparent booster with this control at a minimum. -
Time
Sets the time constants (Attack and Release). You can use the Darkglass Suite to fine-tune and custom map the time constants, you can also assign different behaviors for each Mode. -
Output
Sets the overall output volume of the unit. -
Compression
Sets the overall amount of compression.This control also affects the internal makeup gain. -
Ratio
Adjusts the amount of compression. -
Mode
Selects the unit’s Mode (BUS, FET, or SYM)
Technical Specifications
- Input Impedance: 1M
- Output Impedance: 100
- Current Consumption: 250mA
- Voltage: 9V DC (Center Negative)
Dimensions
- Width: 69.5 mm / 2.73 in
- Length: 111 mm / 4.37 in
- Height: 43 mm / 1.69 in
- Weight: 250 g / 0.55 lb
Warning:
The Hyper Luminal has a current draw of 250mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.
Warranty:
To activate the warranty, we encourage you to register your product on: http://mypedal.darkglass.com and enter the serial number on the back of your pedal. Please contact us via email support@darkglass.com before shipping a product to us.
Disclaimer
In the interest of continuous improvement, specifications are subject to
change without notice.
If you have any questions, please don’t hesitate to contact us at
www.darkglass.com. The manufacturer claims that
the above product fulfills the requirements as set by EN55013, EN55020,
EN60555-2, EN60555-3, RoHS, WEEE.
1176®, and SSL® are registered trademarks of their respective companies. Names
of factory modes are intended for descriptive purposes only and should not be
construed as an endorsement or affiliation with the companies or products
named.
All product names are trademarks of their respective owners, which are in no
way associated or affiliated with Darkglass Electronics.
EMC / EMI
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
PRIVACY POLICY CAREERS
DARKGLASS is a registered trademark in the U.S., number 4,616,801, owned by Darkglass Electronics Oy. Designed by Revolve Studio
FAQ
-
Q: What should I do if I experience noise performance issues with my Hyper Luminal?
A: Ensure you are using a regulated 9V DC adapter with a center-negative plug as recommended. Unregulated power supplies or higher voltages can lead to suboptimal noise performance. If issues persist, contact customer support for assistance. -
Q: How do I know if my product is covered by warranty?
A: Register your product on the provided website and enter the serial number. Contact customer support before shipping for further warranty information.
DARKGLASS is a registered trademark in the U.S., number 4,616,801, owned by
Darkglass Electronics Oy.
Designed by Revolve Studio
MORE INFORMATION
References
- Darkglass Electronics - Login
- Darkglass Electronics - Login
- Darkglass Electronics
- Darkglass Electronics
- Careers – Darkglass Electronics
- Creations – Darkglass Electronics
- Dealers – Darkglass Electronics
- Privacy Policy – Darkglass Electronics
- Suite – Darkglass Electronics
- Darkglass Electronics (@darkglasselectronics) • Instagram photos and videos
- Revolve Studio • Custom Web Design Services in Helsinki
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>