QLIGHT SEN25 General Electric Horn User Manual

June 10, 2024
QLIGHT

General Electric Horn
SRN/ SEN15/ SEN25

QLIGHT SEN25 General Electric Horn

Thank you for purchasing Qlight’s products. Please read this user manual carefully prior to installation and operation to ensure safe and correct use.

Precautions for Safety

Failure to follow the instructions below may cause a loss of life or serious physical injury.

  1. During wiring or maintenance, please completely turn off the power of the product. (Failure to follow this may lead to an electric shock.)
  2. Do not install the product in locations that subjects it to excessive dust or water other than the conditions designated by the IP protection ratings indicated for each product. (Failure to follow these instructions may cause a fire to the product, electric shock, physical injury, malfunction or damage to the product.)
  3. Do not alter or repair this product. If maintenance or repair service is required, please contact your local Qlight contact point. (Failure to follow these instructions may lead to fire, electric shock, or product damage.)
  4. Please apply the correct voltage to the product. (Failure to follow these instructions may lead to fire, electric shock, or product damage.)
  5. When the product is applied to a condition that may impact lives or property, please make sure to have a double safety device. (Failure to follow this may cause damage to property, fire, electric shock and loss of life.)

Precautions for Correct Use

Failure to follow the proper instructions may cause damage to property, the product, and or malfunction of the product that would void the warranty.

  1. Please remove any objects that can interrupt ventilation around the product.
  2. Please turn off the power of the product immediately if it fails to operate properly.
  3. Carefully wire the product according to each product’s specification.
  4. Please be careful in preventing chemicals such as thinner, benzene, etc. in contact with the surface of the product.
  5. Do not apply excessive force/impact to the product.
  6. Failure to follow any of the instructions above may cause malfunction or damage to the product, fire, and electric shock.

Ordering Specifications

QLIGHT SEN25 General Electric Horn - Fig1

Product Specifications

Model number Voltage Current Sound pattern Certificates Weight
SRN DC12-24V Max. 020A .3 WS – 5 Warning sounds

WM – 5 Melodies WA- 5 Alarms
WV – 5 Customizable sounds| | 0.72kg
AC110V| 0.075A| 0.98kg
AC220V| 0.035A
SEN15| DC12-24V| Max.
0.370A| 0.76kg
AC110V| 0.080A| 1.03kg
AC220V| 0.040A
SEN25| DC12V| 2.211A| 0.95kg
DC24V| 1.022A
AC110V| 0.226A| 1.23kg
AC220V| 0.113A

※ CE compliant : DC12V-24V(SRN)
DC12V-24V, AC100V/220V(SEN15/SEN25)

  • Protection rating : IP55
  • Ambient operating temperature : -25°C to +50°C

Dimensions

QLIGHT SEN25 General Electric Horn - Dimensions

Sound Selection and Wiring Instructions

  • Standard : Internal switch
    Internal switch allows to choose sound pattern for SRN/ SEN15/ SEN25 models

QLIGHT SEN25 General Electric Horn - Sound Selection

  • External power line – VCTF(0.75sq x 2C) x 400mm
  • External signal line – UL1007 AWG22(0.3sq) 400mm
  • This product can be wired regardless of polarity.

Mounting Hole Specifications

  • Machine holes on the mounting surface referring to the diagram below.

QLIGHT SEN25 General Electric Horn - Sound Selection1

Sound Selection

QLIGHT SEN25 General Electric Horn - Sound Selection2

  • Standard unit has 5 built-in sound tones.
    Select different built-in sounds using the sound setting switch(①).

Sound Type by Group

Category Sound S pattern Channel Sound tone Volume (Max.)
SRN, SEN15 SEN25
WS 5 Warning sounds Ch1 Fire.A-ANG 108dB
Ch2 Emergency WA-U
Ch3 Ambulance PI-PO
Ch4 Machinery Fault
Ch5 High Expansion
WM 5 Melo-
dies Ch1 Sweet Home 108dB 115dB
Ch2 For Elise
Ch3 Cuckoo’s Waltz
Ch4 Piano Sonata
Ch5 Turkish March
WA 5 Alarms Ch1 Beep Intermittent 105dB
Ch2 Door Chime
Ch3 Phone Ring
Ch4 PI.PI.PI Short
Ch5 Tripping Beat
WV 5 Cus- itemizable
sounds Chi- Ch5 Available upon request

(customized voice
type)| 98dB| 108dB

Volume Adjustment

  • The volume output of this product is adjustable.
  • Turn the volume dial clockwise to increase the volume, and turn counter clockwise to decrease the volume.
  • There will be no sound when the dial is put at MIN.

Parts Definition/ Installation

Parts Definition

■ Installation

  • First, machine holes on the mounting surface
  • The mounting hole of this product is 9mm in diameter.
  • If the tap is machined, fasten the bolt through the mounting hole of the product.
  • When machining holes, insert the bolt through the hole of the product, and tighten the nut from the opposite side of the mounting surface.

Adjusting the Angle of the Horn Housing

  • When adjusting the phase and lower angle of the mixed housing after product cancellation Loosen the bracket fixing bolts(①) on the side of the product slightly to adjust the desired angle.

Precautions for installation

  • In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-down positions where water can potentially penetrate into the product and impact it’s operation.

QLIGHT SEN25 General Electric Horn - Volume
Adjustment1

Installation Environment and Protection Rating

  • This product is designed for use with protection rating of IP55.
  •  If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indicated(IP55), it may cause malfunction or damage to the product.
  • For further information, please visit our website (www.qlight.com).

For your safety

Specification and dimensions listed in this catalogue subject to change without notice for product quality improvement.
The newest product information is available on our website.(www.qlight.com)
Please read the instruction manual attached to the product carefully before installation and use.

Qlight Co., Ltd. www.qlight.com | trade@qlight.com
Head Office | Suite #1510, STX-V Tower, 128 Gasan digital 1-ro, Geumcheon-gu, Seoul, Korea
Tel. +82-2-2679-6152(Toll free. +82-80-328-2222) Fax. +82-2-2679-6154
Factory | 185-25, Mobbing-ro, Sangdong-myeon, Gimhae-si, Gyeongsangnamdo, Korea Tel. +82-55-328-1111(Toll free. +82-80-328-1111)
Light Overseas Sales Dept | 704 Nakdong-daero, Sasang-gu, Busan, Korea (Eomgung-Dong) Tel : +82-51-620-4100
Qlight Public Relations & Marketing Team Office | 704 Nakdong-daero, Sasang- gu, Busan, Korea(Eomgung-Dong) Tel. +82-51-245-0017
Qlight USA, Inc. www.qlight.com www.qlightusa.com | sales@qlightusa.com
3003 North First Street, Suite #341, San Jose, CA 95134 USA Tel. +1 – 408 – 519 – 5740 Fax. +1 – 408 – 519 – 5739
SHANGHAI Qlight Electronic Co., Ltd. www.qlight.com www.qlightcn.com | qlightcn@qlight.com
China Factory/ Shanghai Sales Office | #19, Nanda Road, Baoshan Area, Shanghai, China Tel. +86 – 21 – 6651 – 7100 Fax. +86 – 21 – 6315 – 3929
China Factory Site 2 (Qidong) | #33, Haiyan Road, Qidong High-tech Industrial Development Zone, Qidong, Jiangsu Province, China
Tel +86- 513- 8384- 9999 Fax +86- 513- 8384- 9910

Product Operation Inquiry / Customer Support +82-51-620-4100
You can expect prompt service if you have exact information such as model name, symptom, telephone number and address.
※ALL PRODUCT, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE WITHOUT NOTICE TO IMPROVE
RELIABILITY, FUNCTION OR DESIGN OR OTHERWISE.
Head office : Suite #1510, STX-V Tower, 128 Gasan digital 1-ro, Geumcheon-gu, Seoul, Korea (Postal Code : 08507)
Factory : 185-25, Mukbang-Ro, Sangdong-Myeon, Gimhae-Si, Gyeongsangnam-Do, Korea (Postal Code : 50805)
www.qlight.com
EN – SRN – 2201A
https://www.qlight.com/en/products/?qpcateid=36

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals