DCW EDITIONS M400 PARIS Pendant Lamp Instruction Manual
- June 10, 2024
- DCW editions
Table of Contents
DCW EDITIONS M400 PARIS Pendant Lamp
Product Information
The MONO M400 – L500 – L600 VANTOT is a ceiling fixture that comes with a canopy, lampshade, and a glass ball. The fixture has a touch-dimmer that can be activated or deactivated by touching the light source. It is important to note that the safety of the fixture is only guaranteed if the instructions are followed. The fixture must not be installed in any position other than that shown in the instructions, and assembly and maintenance must be performed carefully so as not to damage components. Replacement bulbs must be of the same type and wattage as specified in the instructions.
Product Usage Instructions
- Remove the plate by taking out the screws.
- Drill the ceiling, insert the plugs, and fix the plate to the ceiling using the screws.
- Connect the electrical supply to the luminaire.
- Fix the canopy on the plate.
- Activate or deactivate the touch-dimmer on the light source by moving it up or down.
- Put the lampshade and the glass ball around the light source then fix everything by screwing the stick.
- Touch the stick to turn the light on/off, and hold down to vary the intensity.
Note: Always disconnect power before working on the fixture.
M400 – L500 – L600
NOTICE DE MONTAGE & D’UTILISATION
INSTRUCTION & USE SHEET
CONTENUTO DELLA SCATOLA
REQUIRED TOOLS
ATTENTION
WARNING
The safety of this fixture is only guaranteed if the instructions have been
observed.
-
Always disconnect power before working on fixture.
-
Fixture must not be installed in any position other than that shown in instructions.
-
Assembly and maintenance of fixture must be performed carefully so as not to damage components.
-
Replacement bulbs must be of same type and wattage as specified in instructions.
-
Metal surfaces, glass or other parts of fixture may be cleaned with a soft damp cloth and mild detergent.
-
DCW ÉDITIONS will replace merchandise with manufacturing defects only if it is returned to the retailer from
which it was purchased. -
If you are unsure about your wiring, please consult a qualified electrician. The damaged cables should be changed by manufacturer or distributor or qualified electrician.
STEP 1
Remove the plate.
STEP 2
Drill the ceiling, insert the plugs, and fix the plate to the ceiling using
the screws.
STEP 3
Connect the electrical supply to the luminaire.
STEP 4
Fix the canopy on the plate.
STEP 5
On the light source, activate or deactivate the touch-dimmer. In the lower
position, the touch dimmer is deactivated, in the upper position, it is
activated.
STEP 6
Put the lampshade and the glass ball around the light source then fix
everything by screwing the stick.
STEP 7
Touch the stick to turn the light on off, and hold down to vary the
intensity.
DCWE.FR
Documents / Resources
| DCW
EDITIONS M400 PARIS Pendant
Lamp
[pdf] Instruction Manual
M400 PARIS Pendant Lamp, M400, PARIS Pendant Lamp, Pendant Lamp, Lamp
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>