SIGNATURE HARDWARE 482644 Edgehill Outdoor Pendant Light Instruction Manual
- June 10, 2024
- Signature Hardware
Table of Contents
SIGNATURE HARDWARE 482644 Edgehill Outdoor Pendant Light Instruction Manual
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric xtures. Signature Hardware accepts no liability for any damage to the
property, the product or for personal injury during installation. Observe all
local electrical building codes.
Unpack and inspect the product for shipping damage. If any damage is found,
contact our Customer Relations team via live chat at
www.signaturehardware.com or by emailing
support@signaturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
FOR YOUR SAFETY POUR VOTRE SÉCURITÉ PARA SU SEGURIDAD
WARNING: Be sure the electricity to the wires you are working on is shut o, either the fuse is removed or the circuit breaker is shut o. You don’t need special tools to install this true. Be sure to follow the steps in the order given. Under no circumstances should a true be hung on house electrical wires, nor should a swag type xture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a quailed electrician .
CARE INSTRUCTIONS
To clean, wipe true with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
TOOLS AND MATERIALS:
INSTALLATION (FIG.1)
- Shut off the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Attach the mounting bracket (B) to the outlet box (A) (not supplied) using the 2 screws provided with the outlet box (A). Then screws collar loop(H) through canopy and install onto the nipple (D). When the screws collar loop(H) is correctly adjusted, remove the canopy (M) and tighten the top hex nut (E) against the mounting bracket(B) and the bottom hex nut (G) against the screws collar loop (H). Attach the Chain to the fixture with the Quick Link (J).
- Weave the wires through every third chain link(I).Continue to pass the wires through the screw collar ring (N) and canopy (M).Pass the wires through the screws collar loop(H) and up into the outlet box(A).
- 5.CONNECTING THE WIRES : Now connect the electrical wires as follows: Connect the smooth wire from the fixture to the black or red (lead) supply wire. Connect the ridged wire from the fixture to the white (neutral) supply wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet h as a ground wire (green or bare copper),connect fixture’s ground wire to it. Otherwise. connect fixture’s ground wire directly to the crossbar using the green screw provided. Tuck the wire connections neatly into the ceiling junction box.
- Move up the canopy (M) to the ceiling and secured by the screw collar ring (N) to the screw collar loop (H).
- Install the bulb: first twist down the screws(P), take the cage (S) away from the roof(O), put the candle covers(Q) onto the sockets. Then thread the bulbs(Not included. Don’t exceed the maximum capacity recommended on the sockets) into the fixture sockets. Finally, fit the cage(S) back to the roof with the screws(P) that was removed before, twist up the screws(P).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>