SIGNATURE HARDWARE 440744 Birkdale Sconce Wall Lamp Sconce Murale Instruction Manual
- June 10, 2024
- Signature Hardware
Table of Contents
BIRKDALE SCONCE
SKU: 440744
440744 Birkdale Sconce Wall Lamp Sconce Murale
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer Relations team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation.
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com. FOR YOUR SAFETY POR SU SEGURIDAD
WARNING: Be sure the electricity to the wires you are working on is shut
off, either the fuse is removed or the circuit breaker is shut off. You don’t
need special tools to install this fixture. Be sure to follow the steps in the
order given. Under no circumstances should a fixture be hung on house
electrical wires, nor should a swag type fixture be installed on a ceiling
which contains a radiant type heating system. Read instructions carefully. If
you are unclear as to how to proceed, consult a qualified electrician.
CARE INSTRUCTIONS INSTRUCCIONES
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not
use brasive materials such as scouring pads or powders, steel wool or abrasive
paper.
TOOLS AND MATERIALS:
SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE.
READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT
OR INSTALLATION QUESTIONS PLEASE CALL
CUSTOMER SERVICE AT 1-800-221-3379.
INSTALLATION (FIG 1)
INSTALLATION (FIG 1)
-
Thread the mounting screws (A) into the matching holes in the circular strap (B).
-
Secure circular strap (B) to the outlet box with outlet box screws (C).
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the circular strap.
Note: If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected, tuck them carefully inside outlet box. Raise the front plate (D) allowing for the mounting screws (A) to protrude through the holes on
front plate (D), and secure with the ball nuts (E).
INSTALLATION (FIG 2)
- Place the cap (G) onto the candle sleeve (F).
- Install light bulb (H) (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket.
REVISED: 11/29/2021
CODES: PHWL3081
1.855.715.1800
signaturehardware.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>