SIGNATURE HARDWARE 440676 Foxfield Outdoor Wall Sconce Instruction Manual
- June 10, 2024
- Signature Hardware
Table of Contents
440676 Fifield Outdoor Wall Sconce
Instruction Manual
440676 Fifield Outdoor Wall Sconce
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes. Unpack and inspect the product
for shipping damage. If any damage is found, contact our Customer Relations
team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for
the installation.
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at
www.signaturehardware.com for product and
warranty information, or contact us through live chat or by emailing
support@signaturehardware.com.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully, if you are unclear as to how to proceed, consult a qualified electrician.
TOOLS AND MATERIALS
| Mounting Hardware
---|---
| Wire Connector
| Outlet Box Screws (2pcs)
| Cap Nuts (2pcs)
| Ground Screw (1pc)
INSTALLATION
- Shut off the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Thread the 2 Mounting Screws (C) to the Mounting plate (E). (You can adjust the length of the screws if necessary.)
- Attach the Mounting plate(E)to the Outlet Box (G) (not supplied) by using 2 Outlet Box Screws (B).
- Now connect the electrical wires as follows: Connect the black wire from the fixture to the black house (hot) wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to the mounting plate using the green screw provided. Tuck the wire connections neatly into the junction box.
- Attach the Fixture (H) to the Mounting Plate by inserting the 2 Mounting Screws (C),and then secure with the 2 Cap Nuts (F).
- To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e.. Indoor/Outdoor Silicone Sealant) to outline the outside of fixture backplate where it meets the wall
leaving a space at bottom to allow moisture a means to escape.
1.855.715.1800
signaturehardware.com
Documents / Resources
|
SIGNATURE HARDWARE 440676 Foxfield Outdoor Wall
Sconce
[pdf] Instruction Manual
440676 Foxfield Outdoor Wall Sconce, 440676, Foxfield Outdoor Wall Sconce,
Outdoor Wall Sconce, Wall Sconce
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>