namron 5401360-61 Terrace Heater WiFi 2000W Instruction Manual

June 10, 2024
NAMRON

namron 5401360-61 Terrace Heater WiFi 2000W

namron-5401360-61-Terrace-Heater-WiFi-2000W-fig-1

PRODUCT INFORMATION

The Namron Terrassevarmer WiFi 2000W is an outdoor patio heater that operates on a voltage of 220-240V~ 50/60Hz and has an IP44 rating. It comes with a 1.5-meter cable and a remote control that uses a CR2025x1 battery. The heater has three power settings: 750W, 1500W, and 2000W.

Mounting

  1. Before mounting, ensure that the minimum mounting distance is maintained (see Fig1).
  2. Fix the mounting bracket on the wall using three screws (see Fig2 and Fig3).
  3. Check the rocker power switch on the right side of the heater before fixing it to the bracket using two screws and wing nuts.
  4. Plug in the power source and turn on the heater.
    Note that the heater must be placed at a safe distance of at least 1 meter from flammable material.

Remote Control

The remote control has four buttons:

  • Button 1: Low heat (750W)
  • Button 2: Moderate heat (1500W)
  • Button 3: High heat (2000W)
  • Button 4: Power on/off

WiFi Connection

The Namron Terrassevarmer WiFi 2000W can be connected to a WiFi network using the following steps:

  1. Download and install the Tuya Smart app on your mobile phone and register.
  2. Connect the heater to the power and press the power on/off button on the heater to turn it on. Wait until the blue light starts to blink, indicating that the patio heater is ready to be paired with the phone or smart device.
  3. Open the app on your phone or smart device and select “Add Device”. Follow further instructions in the app.
  4. If the blue light is constant and does not flash, reset the device first. To do this, turn on the heater and wait for the red light to start blinking. Press the 750W button three times continuously, then press the 1500W button once. The WiFi of the heater will be reset, and the blue indicator light will start blinking.
    Disconnect power during maintenance and when the heater is not in use. Make sure that the outlet is grounded for safety.

PRODUCT SPECIFICATION

  • Operating voltage: 220-240V~ 50/60Hz

  • Effect: 750W/1500W/2000W

  • IP Rating: IP44

  • Included 1.5 meter cable.

  • Max. remote control distance: 5m.

  • The remote control uses CR2025x1 battery.

MOUNTING

  1. Before mounting, the minimum mounting distance must be followed Fig1.
  2. Fix the mounting bracket on the wall Fig2 and Fig3 with three screws.
  3. Before fixing the heater, check the rocker power switch on the right side and then fix the bracket and heater by two screws and wing nuts.
  4. Plug in the power source and turn on the heater.

namron-5401360-61-Terrace-Heater-WiFi-2000W-fig-2

SAFETY

  • This heater is hot when in use. Do not cover the heater surface, the heater can become very hot and must be placed at a safe distance from flammable material (Min. 1meter).
  • Disconnect power during maintenance and when the heater is not in use.
  • Make sure that the outlet is grounded.

MEASURES

namron-5401360-61-Terrace-Heater-WiFi-2000W-fig-3

REMOTE CONTROL

 | FUNCTION|
---|---|---
1.| On/Off|

Switch on or off the heater.

2.| First gear| After turning on the heater, you can choose low heating.
3.| Second gear| After turning on the heater, you can choose moderate heating.
4.| Third gear| After turning on the heater, you can choose high heating.

BLE wifi connection method

  1. Download and install Tuya smart app with mobile phone and register.

  2. Connect the heater to the power and press on/off button on the heater to turn on. Wait until the blue light start to blink, this indicates that the patio heater is ready to be paired with the phone or smart device. Open the app in the phone or smart device, and select “Add device”.
    Attention! If the blue light is constant and does not flash; see point 4 below before continuing.

  3. Follow further instructions in the app.

  4. If the blue light does not blink, the device must be reset first. This is done with remote control: Turn on the heater and wait the red light is blinking. Press 750W button 3times continuous, then press 1500W one time. Then the wifi of the heater will be reset. Blue indicator light will be blinking.

ABOUT COMPANY

  • Namron AS
  • Nedre Kalbakkvei 88B, N
  • 1081 Oslo
  • NORWAY

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

NAMRON User Manuals

Related Manuals