ECHOMASTER CVBS Blind Spot Dual Side View Camera kit Installation Guide
- June 10, 2024
- Echomaster
Table of Contents
Blind Spot Dual Side View Camera Kit
CVBS (480P)
AHD (720P)
2007 – 2018 Wrangler JK (HDBJK)
2018 – Up Wrangler JL / Gladiator JT (HDBJL)
Installation Notes
Camera brackets are non-directional and can be installed on either side.
If the video source does not have multiple inputs and turn signal triggers, a
PAC VS-41 is required.
To connect blind spot cameras to the JK factory display radio, a PAC BCI-CH21
and VS-41 is required.
Box Contents
- Blind Spot Cameras (2)
- Mounting Brackets (2)
- Camera Extension Cables (2)
- Camera Power/Video Adapters (2)
- U-Shaped Camera Angle Adjustment Tool
- Warranty Card
Mounting The Cameras
Using a 10mm socket, loosen the front fender bolt (1) located inside the door
jamb.
Feed the camera cable through the bracket opening (2).
From outside the vehicle, carefully slide the camera mounting bracket between
the fender and the door.
Route the camera cable behind the bracket and upward (3).
Slide the mounting bracket under the the 10mm bolt and washer. Hand tighten
the 10mm bolt.
Align the bracket so it is flat against the fender and ensure the camera cable
is routed in the space behind the bracket.
Tighten the 10mm bolt (1).
Aligning The Cameras
Using the U-Shaped Camera Angle Adjustment Tool, rotate the cameras so that
the White Mark is at the top.
Once the cameras are connected to a video source, they can be further adjusted
to ensure the image is straight and the viewing angle shows the vehicle’s
blind spot.
Wiring Overview
Once the cameras are mounted, route the camera cables into the engine
compartment. Connect the Camera Extension Cables and route the cables into the
vehicle to the video source. Connect the Camera Power/Video Adapters to the
camera cables. Connect the Red wire to a switched 12V+ source and the Black
wire to Ground. Connect the Yellow Video RCA cables to the appropriate inputs
on the video source. 
Camera Specifications
| Sensor Type | CMOS |
|---|---|
| LEDs | 4 |
| Illumination | 0.1 LUX |
| Viewing Angle (Diagonal) | 80 degrees |
| Mirror Image (Selectable) | Selectable |
| Parking Lines | Selectable |
| Water/Debris-Proof | 1967 |
| Audio | NO |
| Power Supply | DC9-16V |
| Current | <150mA |
| Working Temperature | -20°C – 65°C |
| Dimensions (MM) | D (26) x W (50) x H (23) |
| System | CVBS / AHD |
| TV Lines | 480 / 720 |
| Resolution (HxV) | 648 x 488 / 1280 x 720 |
TECHNICAL SUPPORT: Phone: 727-592-5991
Email: support@aampglobal.com
Chat: EchoMasten.com
CUSTOMER SOLUTIONS: 800-477-2267
Ca 2021 AAMP Global
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>