CREATE Chopping Board Scale Bamboo User Manual
- June 10, 2024
- CREATE
Table of Contents
CREATE Chopping Board Scale Bamboo
Thank you for choosing our chopping board with scales. Before using the
appliance, and to ensure the best use, carefully read these instructions.
The safety precautions enclosed herein reduce the risk of death, injury and
electrical shock when correctly adhered to. Keep the manual in a safe place
for future reference, along with the completed warranty card, purchase receipt
and package. If applicable, pass these instructions on to the next owner of
the appliance. Always follow basic safety precautions and accident-prevention
measures when using an electrical appliance. We assume no liability for
customer failing to comply with these requirements.
SECURITY INSTRUCTIONS
Before using this electrical appliance, the following basic precautions should always be followed:
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- This product is intended only for domestic use.
- Place the scale on a hard and flat surface when you weigh. Do not use on a carpet or similar surfaces.
WARNING: This product is a sensitive electronic instrument and it may be temporarily affected by radio transmitting devices being used in close proximity to it (mobile phones, radio model controllers and some microwave ovens, etc.) It can also be affected by extreme levels of electrostatic interference. Then, it may be necessary to remove and re-install the battery to re-establish normal working. If the problem persists, contact our after sales service.
PARTS LIST
- Chopping surface
- Weighing surface
- Unit button
- LCD screen
- ON/ZERO button
OPERATING INSTRUCTIONS
HOW TO USE THE SCALE
- Put the scale on a hard and flat surface.
- Place a bowl (if needed) on the scale before turning on the unit.
- Press and release the ON/ZERO button to turn on the unit.
- Wait until the display shows “Og” before starting weighing.
HOW TO CHANGE WEIGHT UNITS
- Once the scale is on, press the button “UNIT” to toggle between “g” and “oz”.
- You can do it with or without load on the scale.
ZERO AND TARE FUNCTION
- To weigh different loads consecutively without removing loads from the scale, put first load on the scale and get weight reading.
- Press ON/ZERO button to reset the LCD reading to O before adding next load.
- Repeat this operation as many times as you need.
There are two procedures:
ZERO function:
- The LCD screen will show “Og” each time ON/ZERO is pressed.
- A number O will be shown on the lower right corner of the screen, indicating that the ZERO function is active.
- Max. capacity remains unchanged every time ON/ZERO is pressed.
TARE function:
- The LCD screen will show “Og” each time ON/ZERO is pressed.
- The icon TARE will be shown on the lower left corner of the screen, indicating that the TARE function is active.
- Max. capacity is reduced by the total weigh of all loads.
WARNING: When the scale is overloaded, the LCD screen will show EEEE. Take off the load so as not to damage the product.
HOW TO SWITCH OFF THE SCALE
- Auto shut-off occurs when the display shows O or the same weigh reading for 45 seconds.
- To save battery, keep pressed the ON/ZERO button to shut down the scale after each use.
HOW TO REPLACE THE BATTERY
- Remove the battery compartment cover and attach a new battery onto the battery snaps.
- Make sure to match the polarities correctly.
WARNING: When the battery is low the LCD screen will show LO. Replace the battery.
CLEANING AND STORAGE
- Use a wet cloth for cleaning. Do not clean the surface with chemicals or corrosive cleaners.
- Do not immerse it into water and store it at a cool, dry and ventilated place.
- Do not cut too hard pieces on the surface of the chopping board.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in electric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package indicates that the product at the end of its service life shall be collected as separate waste. Therefore. any products that have reached the end of their useful life must be given to waste disposal centres specializing in separate collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled, treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the environment and health and optimizes the recycling and reuse of components making up the apparatus. Abusive disposal of the product by the user involves application of the administrative sanctions according to the laws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>