INSPECT USA Solo 461 Cordless Heat Detector Tester User Manual

June 9, 2024
INSPECT USA

Solo 461 Cordless Heat Detector Tester

| |
---|---|---
Insert a charged battery baton into the tool and pole.
Caution Ensure correct orientation when inserting battery baton into tool and do not use undue force to insert.| Press the red switch to turn on. LED illuminates green.
Flash at slow rate indicates normal STANDBY mode.| Position the latch and place over detector.

4 The tool will automatically start testing when infra-red beam in cup is broken. The green LED will flash faster. Hold in place until the alarm is activated. When the detector alarms, remove the tool from the detector.
It will revert to standby mode (slow flashing green LED), and the internal blower will cool the heating element for a few seconds. After testing, switch off at red switch to preserve battery baton life.
(
If the detector fails to activate it may be faulty. Insert a replacement detector and test again)
Caution Remove battery baton when not in use.

Solo Battery Baton Charging

Connect charger to power outlet or vehicle accessory socket using power cable supplied or the umbilical DC connecting lead. LED will not illuminate permanently.
Warning Do not attempt to use or charge the battery baton if either the charger unit or the battery baton connection point are damaged.

Connect battery to charger. LED will flash red/green, then red only to show fast charging. LED is green only when battery is fully charged. If LED flashes red, there is a battery fault.

Red/Green Flashing Battery TRed
Green
Ready for Use
Red Flashing
| Red/Green Flashing Battery Testing
Fast Charging
Ready for Use
Battery Fault
---|---

Tip: Ideally, fully discharge battery baton in normal use before recharging.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals