ESR 6B013 Velocity 85 Wireless Mechanical Keyboard User Guide
- June 9, 2024
- ESR
Table of Contents
VELOCITY85
WIRELESS MECHANICAL
KEYBOARD
User Guide
Using Your Keyboard
| Wired Mode | Slide switch to “cable ” and connect via USB-C cable. |
|---|---|
| Wireless Mode | Slide switch to “bluetooth ” and long press for 3 seconds to |
enter pairing mode. Key that was pressed to pair will flash white to indicate
that keyboard has entered pairing mode. If not connected after 3 minutes,
pairing mode will turn off.
Connection methods| Bluetooth or USB-C cable.
Maximum paired Bluetooth devices| 3
Bluetooth pairing name| Velocity85
Switch active device| Press to select paired devices.
Turn off| Slide switch to “cable ” when USB-C cable is not connected to turn
off.
Backlight| Press to cycle through RGB light modes.
Brightness| Backlight has 5 brightness levels. Press to increase brightness
and to decrease brightness. Keys flash white 3 times to indicate minimum or
maximum brightness level has been reached.
Status light guide| Low battery:
Charging:
Fully charged:
Standby mode| Keyboard backlight will turn off automatically after 1 minute of
inactivity.
After 30 minutes of inactivity, keyboard will enter standby mode and Bluetooth
will disconnect. Press any key to wake keyboard and automatically reconnect
via Bluetooth.
Switch operating systems| Press to switch to macOS configuration. Press 
to switch to windows configuration. Key that was pressed
to switch will flash white 3 times to indicate configuration has been changed.
Factory reset| Long press for 3 seconds to perform a factory reset.
Troubleshooting Guide
If keyboard is unresponsive in wireless mode:
- Ensure switch is set to “bluetooth ”.
- Ensure keyboard has sufficient charge. If battery is low, charge keyboard.
- Ensure correct paired device is active by pressing to select paired devices.
- If keyboard still doesn’t work, forget device, factory reset keyboard, and pair again.
If keyboard is unresponsive in wired mode:
- Ensure switch is set to “cable “.
- Ensure you are using included cable. Third-party cables may not be compatible with keyboard.
If keys don’t match paired device’s operating system:
Ensure keyboard is set to correct configuration by pressing to switch to
macOS configuration or to switch to windows configuration.
If problem persists, repeat the above steps.
If you are still experiencing problems, contact customer service of website,
app, or store that keyboard was purchased from for further assistance.
Important Reminder
This keyboard has a rechargeable battery. When not using keyboard for an
extended period of time, turn keyboard off and charge once every 3 months to
prolong battery life.
FCC ID:2APEW-6B013
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
IC:24790-6B013
This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.”
RF exposure statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
**** This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
This product is intended for use within Europe. Electronic Silk Road Corp.
hereby declares that this product 6B013 is in compliance with the essential
requirements and other relevant provisions of Directive
2014/53/EU,2014/35/EU,2014/30/EU. The Declaration of Conformity for the 6B013
is available from www.esrgear.com
This symbol indicates that this product shall not be treated as household
waste. Instead it shall be handed over to the applicable collection point for
the recycling of electrical and electronic equipment.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>