Continental Edison CEVCB230B Vacuum Cleaner Instruction Manual
- June 4, 2024
- Continental Edison
Table of Contents
Continental Edison CEVCB230B Vacuum Cleaner
IMPORTANT SAFETY INSTRUCTIONS
- Please read the manual before use.
- If the supply cord IS damaged, It must be replaced by the manufacturer, its service agent or qualified persons in order to avoid a hazard.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand
- The hazards involved.
- Cleaning and user maintenance shall not be made by children without supervision.
- Children should not play with the appliance.
- The appliance is only to be used with the power supply unit provided with the appliance.
- The appliance must only be supplied at safety extra low voltage corresponding to the marking on the appliance.
- If the batteries are damaged, It must be replaced by the manufacturer, its service agent or qualified persons in order to avoid a hazard.
- The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
- Please keep the vacuum cleaner in laid down position when storing.
- The vacuum cleaner can’t stand by itself, please put it to the base stand after use.
- When you pause using the vacuum cleaner please put it to the base stand or leave it in laid down position.
- Before charging, read the instructions.
- For indoor use only, do not expose to rain.
- WARNING: Explosive gases. Prevent flames and sparks. Provide adequate ventilation during charging
- Disconnect the supply before making or breaking the connections to the battery.
- Beware of the risk of being caught in hair and loose clothing.
- The charger must not be used if the enclosure is damaged because this will cause hazard of electric shock.
- Damaged batteries must be replaced with new battery of the same type provided by the manufacturer.
- The battery charger is designed for charging the rechargeable battery provided by manufacturer.
- Do not use any other charger to recharge the battery provided by manufacturer and do not try recharge other types of battery with this charger. Also do not try to charge non-rechargeable batteries with this charger.
- Before charging, check whether the voltage specified on the marking label corresponds to the mains voltage.
- During charging, the appliance must be placed at well-ventilated area.
- Keep the charger from all sources of heat.
- Do not insert any item through the ventilation slots on the charger.
- Do not expose the charger to rain, snow or any other environment of high humidity.
- Do not immerse the appliance in water.
- When separating the charger from the socket, pull the body of the plug rather than the supply cord; this will avoid hazard.
- Do not continue to use the appliance in such and similar cases: drop, impact by a heavy object, other means of damage, etc. If it occurs, get the charger repaired by our service agent.
- Do not disassemble the battery charger by yourself to avoid fire hazard or electric shock.
- Please remove the plug from the socket before cleaning or maintaining the charger.
Product Instruction
Installation
Other accessories list Reminder
Accessories can be installed on the extension tube when clean high area
Installation and use of wall mount
-
Place the bracket on the wall and fix it with two screws.
-
Place the vacuum cleaner on the support: Keep the cleaner in the power-off state, and align the hook hole on the main body (back) to the hook of the wall mount.
Operation Instructions
- Press the “Start Button” to start cleaning;
- Press the “Start Button” again to stop cleaning;
- The flashing of indicator light 1, 2 and 3 at the same time indicates a warning requiring the service from professionals;
- The default mode after starting the cleaner is at Middle level. Press the “Power Regulation Button” to change to the High level. Press the button to change to the Low level. The speed is regulated in the order of Middle level, High-level and Low level in a circle.
- Battery level indication during charging: The indicator 1 blinks for low power, and the charging shall be continued. The indicator 1 to indicator 3 are on at the same time for full power, which will be off after the cleaner has been fully charged for a while;
- Battery level indicator during operation (discharging): Indicator 1 to indicator 3 are on t the same time for sufficient battery power, and the cleaner could be used. Indicator 1 blinks for low power and the cleaner shall be charged timely.
Cleaning and Maintenance
Disassembly, installation and cleaning of dust bin bin
Attention
To maintain the suction power of the vacuum cleaner, please clean it
regularly.
Disassembly of dust bin
Place the cleaner in the way shown in the picture with the hand grabbing the
bottom of the dust bin.
Press the dust bin release button and pull down the dust bin to remove it.
Installation of dust bin .Push the dust bin upward into with the suction port facing outward, until a click could be heard.
Empty the dust bin Press the release button of the dust bin, the bottom lid of the dust bin will open automatically, enabling one-touch dust emptying .
Disassembly and cleaning of filter components
Attention
-
Ensure that the components are installed in place, otherwise product failure may be caused;
-
Do not let water get into the electrical components of the vacuum cleaner, otherwise product failure may be caused.
-
Gently remove the filter components from the dust bin assembly by holding the tendon positions on both sides with hands;
-
Remove the filter sponge and pat it; (filter sponge must not be tapped in reverse) (filter sponge must not be tapped in reverse)
-
Remove the cyclone system by rotating it as shown in the picture and clean it.
Disassembly and cleaning of electric brush
Attention
-
To ensure the normal operation of the electric brush, please clean it timely in case that the rolling brush and wheels are tangled or dirty;
-
When disassembling it for maintenance, please be sure to stop the operation of the electric brush;
-
Water is not recommended for cleansing the electric brush. The hairs winding on it could be removed with scissors. The dust on the rolling brush could be removed with hair brush.
-
Press the button to remove the electric brush;
-
Rotate the brush end cap upward and remove it, then remove the brush and clean it. After cleaning the brush, reinstall it in the reversed order as above. After cleaning the brush, reinstall it in the reversed order as above.
Troubleshooting
In case of any abnormal conditions when using this product, please read the following table first.
Abnormal condition | Possible cause | Action |
---|---|---|
Three indicators blink | The brush is entangled | Clean the floor brush or mite |
Ambient temperature is too | brush | |
high or too low | Use the cleaner in a proper | |
environment | ||
Electric brush does not work | Any large garbage (e.g. | Remove the hair on the |
packing film) is rolled into | brush | |
the cleaner | Remove the garbage | |
The brush is tangled by hair | ||
Operation duration | Aged battery | Contact the store or post- |
shortened | Ambient temperature is too | sales service to purchase a |
high or too low | new battery | |
The battery is not fully | Use the cleaner in a proper | |
charged | environment | |
– Charge the cleaner | ||
Suction power weakened | Too much dust in dust bin | Remove the garbage timely |
Filtering sponge is blocked | Clean the filtering sponge | |
Brush or accessory suction | Remove the blocking things | |
port is blocked | Put the components in a | |
– Not fully dried after washing | cool place for drying after | |
with water | washing them with water | |
The cleaner could not be | Ambient temperature is too | Put the cleaner in a |
proper
charged| low or too high during| place for charging at
| charging| appropriate temperature
Battery liquid leakage| The battery is not used for a| Change the battery
| long time|
SPECIFICATION
- Item reference : CEVCB230B
- Model : V21Q01Q32226EU
- Voltage : 21.6V
- Wattage : 250W
- Battery : 2000mAh
- Instruction ma n ual versi o n: Vl
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the – return and collection systems or contact
the retailer where the product was purchased. They can take this product for
environmental safe recycling.
Continental Edison
120-126 Quai de Bacalan
cs 11584
33000 Bordeaux
IMPORT BY :
AMC
123, QUAI JULES GUESDE
94400 VITRY SUR SEINE
France
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>