KLIM ACE Wireless Gaming Mouse User Manual
- June 9, 2024
- KLIM
Table of Contents
KLIM ACE Wireless Gaming Mouse
USER MANUAL
KLIM ACE WIRELESS GAMING MOUSE
PACKAGE CONTENTS AND PRODUCT DIAGRAM
| Mouse | Charging cable |
|---|---|
| Instruction manual | 2.4G wireless receiver |
| 1. Left button | 7. Volume + |
|---|---|
| 2. Right button | 8. Volume – |
| 3. Scroll wheel (middle button) | 9. Power switch |
| 4. DPI button | 10. USB receiver |
| 5. Forward | 11. USB-C port |
| 6. Back | 12. Gliding pads |
HINT: Remove the protective film from both sets of gliding pads under the mouse (12)
QUICK START GUIDE
Wired mode
Connect the USB cable to the mouse’s USB-C port (11), and the other end to
a USB port on your computer.
Wireless mode
- Take the USB receiver underneath the mouse and plug it to a USB port in your computer
- Flick the power switch under the mouse to one of the two ON positions, as seen below.
Note: it is recommended to complete a full charging cycle before the first use in wireless mode
CHARGING THE BATTERY
The light on the logo indicates the status of the battery:
- Red light (flashing): low battery
- Yellow light : charging
- Green light : Full battery
When the mouse battery is low, connect the cable to your computer or an external power source (such as a USB charger) to charge your mouse. You may continue to use it while it charges.
Power saving function
In order to preserve battery life, the mouse sensor turns off after 1 minute
of inactivity while on a wireless connection and the lights turn off after 3
minutes of inactivity. Press any button to reactivate the mouse.
Tip : lowering the brightness or switching off the RGB lighting
completely significantly increases the battery life and reduces the frequency
of charges.
Note: while in wired mode, the mouse lights might stay on even after the
power is off due to the computer settings. If you prefer them to be turned
off, check your ERP settings (advanced users only!), or contact our support
team.
ADVANCED FEATURES
Polling Rate – press and hold the middle (3) and right (2) buttons for 3
seconds to cycle through each Polling Rate setting. The wheel light briefly
flashes to indicate the current setting: 1000 Hz (purple) – 500 Hz (green) –
250 Hz (blue).
DPI indicator – the logo on the mouse indicates the current DPI level:
800 (red) / 1200 (green) / 2000 (blue) / 3200 (cyan) / 5000 (purple).
Press and hold the middle button (3), then press the back button (6) to switch
between the three available modes for the logo light: always on, breathing,
neon.
Side RGB lights – press and hold the middle button (3), then click the
forward button (5) to change the light effects.
Customization software
Access to advanced customization options such as mouse key remapping, macros
and multiple RGB effects and colors by downloading the drivers at
www.klimtechs.com/drivers. Available for
Windows only.
Important note for left-handed users: you may swap the side button’s
functionality using these drivers to have forward/back accessible from your
left thumb.
CONTACT AND TROUBLESHOOTING
Do you need additional assistance with your product? Contact us at support@klimtechnologies.com. Our team of specialists is at your disposal and will always reply within 24 hours!
| Problem | Solution |
|---|
The mouse does not work
| 1. Fully charge the battery or try wired mode.
2. Ensure the switch under the mouse is in the right position.
3. Make sure that the receiver is properly connected. Try plugging it to a different USB port.
4. Contact our support team.
The cursor jitters
/ mouse stops working momentarily
| 1. Check that there are no obstacles between the USB receiver and the mouse. Try plugging the receiver to a frontal USB port if available.
2. Move the mouse closer to the receiver.
3. Fully charge the battery.
4. Place the mouse on a non-reflective surface such as a mouse pad.
Authorised EU representative Marcus EXcelsior Limited Bracken Road No 51,
Carlisle Offices D18CV48 Dublin, Sandyford Dublin, Ireland
Marcus Excelsior Limited
2512 Langham Place Office Tower 8 Argyle Street, Mongkok, Kowloon Hong Kong
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>