IMETEC TYPE R5902 Electric Hand Blender Set Instructions
- June 9, 2024
- IMETEC
Table of Contents
TYPE R5902 Electric Hand Blender Set
Instructions
ILLUSTRATIVE GUIDE
INTRODUCTION
Dear customer, thank you for choosing our product. We feel certain you will
appreciate its quality and reliability as it was designed and manufactured
with customer satisfaction in mind. These instructions for use are compliant
with the European Standard EN 82079.
WARNING! Instructions and warnings for safe use. Before using this
appliance, carefully read the instructions for use and in particular the
safety notes and warnings, which must be complied with. Keep this manual
together with its illustrative guide for future consultation. Should you
transfer the appliance to another user, make sure you hand over this
documentation as well.
NOTE: should any part of this manual be difficult to understand or any
doubt arise, contact the company at the address indicated on the last page
before using the appliance.
NOTE: partially sighted persons can consult the digital version of these
instructions for use on the website
www.tenactagroup.com
SAFETY NOTES
- After unpacking, make sure the appliance is intact, complete with all its parts as shown in the illustrative guide and with no sign of damage. If in any doubt, do not use the appliance and contact an authorised service centre.
**CAUTION! Remove any communication material such as labels, tags etc.
from the appliance before use.
WARNING!** Risk of suffocation. Children shall not play with the packaging.
Keep the plastic bag out of the reach of children.
- This appliance must be used only for the purpose for which it was designed, namely as a hand-held blender with chopper for home use. Any other use is considered not compliant with the intended use and therefore dangerous.
WARNING! Any misuse of the appliance may lead to injuries.
- Before connecting the appliance to the mains supply, make sure that the voltage and frequency indicated on the technical data of the appliance correspond to those of the mains supply. The rating is on the appliance or on the power supply unit, if any (see illustrative guide).
- This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
- This appliance shall not be used by children. Keep the appliance and its cord out of reach of children. Children shall not play with the appliance.
- Ø DO NOT use the appliance with wet hands, damp feet or barefoot.
- Ø DO NOT pull the supply cord or the appliance itself to remove the plug from the socket.
- Ø DO NOT pull or lift the appliance by the supply cord.
- Ø DO NOT expose the appliance to humidity, to the effects of weather (rain, sun, etc.) or to extreme temperatures.
- Ø The appliance is not to be used outdoors.
- Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling, cleaning and when the appliance is not in use.
- If the appliance is faulty or malfunctions, switch it off and do not tamper with it. Contact an authorised technical service centre for any repairs.
- If the supply cord is damaged it must be replaced by an authorised technical service centre, so as to prevent all risks.
- The motor body of this appliance shall not come into contact with water, other liquids, spray, steam. For any cleaning and maintenance operation refer to the instructions in the relevant chapter.
- Ø DO NOT use this appliance near a washbasin or a sink filled with water. During use the appliance must be placed in such a way that it cannot fall in the washbasin or the sink.
- See the external packaging for the characteristics of the appliance.
- Use the appliance only with the supplied accessories that are an essential part of the appliance.
- This appliance is not intended to be operated by means of an external timer or separate remote-control system or any other similar system.
- Ø DO NOT use near a hob. The supply cord shall not come into contact with hot, incandescent surfaces, open flames, pots and other utensils.
- Ø DO NOT leave food in contact with the appliance for any longer than is necessary for preparation.
**WARNING!** Take care when handling the sharp cutting blades, emptying the bowl if any and during cleaning.
**WARNING!** Remove the pot from the hob and let the liquid cool down before blending it. DO NOT immerse the steel stem in hot liquids over 70°C and do not take it out of the liquid while the appliance is still on.
**WARNING!** Remove the pot from the hob and let the liquid cool down before blending it. DO NOT immerse the plastic stem (if applicable) in hot liquids over 40°C and do not take it out of the liquid while the appliance is still on.
- Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.
KEY TO SYMBOLS USED
**** | Caution/Warning | Prohibition | |
---|---|---|---|
Class II appliance | Open | ||
Closed | Closing and opening indication |
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES
Refer to the illustrative guide on page I to check that your appliance is
complete with all accessories.
1. Start button | 7. Plastic stem (if present) |
---|---|
2. Motor unit | 8. Power cable |
3. Technical data | 9. Chopper bowl (if applicable) |
4. Stem base | 10. Chopper blades (if applicable) |
5. Stem | 11. Chopper lid (if applicable) |
6. Blades | 12. Jug |
The multipurpose chopper attachment (Code DG3010) may be purchased as an accessory from any authorised Imetec service centre or from the website shop. imetec.com
CONTACT WITH FOOD
To ensure safe use of the device, respect the indications in this table which show:
- parts of the appliance intended for contact with food; the parts of the appliance not indicated in the table are not meant to come into contact with food.
- Foodstuffs that can be used with this device.
- The maximum time that food may remain in contact with the parts of the device designed for that purpose.
- The maximum permitted temperature of the food used.
List of parts | Food | Maximum time | Maximum temperature |
---|---|---|---|
5. Stem | All | 5 minutes inuest | 70 °C |
9 – 10 – 11. Chopper bowl, blades and lid
(if applicable)| 40 °C
7. Plastic stem (if applicable)
12. Jug
USING THE HAND BLENDER
**WARNING!** Before use, wash all parts which will come into contact with food.
- Clean the accessories according to the following table:
Accessory| Under running water at a
temperature not exceeding 60°C| In the dishwasher at a
temperature not exceeding 60 °C| Wipe with a dampened and thoroughly squeezed
out sponge
---|---|---|---
4-5-6-7. Stem and blades| /| NO| ✓
9.Chopper bowl (if applicable)| ✓| ✓
10.Chopper blades (if applicable)| I/| ✓
11.Chopper lid (if applicable)| NO| NO
12.Jug| ✓| ✓
- Dry with a dry cloth
OPERATION
The appliance has the following functions:
Control | Function |
---|---|
1. Start button | Activates the device, if pressed it will operate in |
continuous mode.
If pressed and released, it will operate in pulse mode.
QUANTITIES AND MAXIMUM USAGE TIMES
Do not exceed the MAX level indicated on the chopper bowl (if applicable)
and on the beaker.
Accessory | Ingredients and maximum quantities | Time |
---|---|---|
Stem and jug | Carrots: 280 g Water: 420 g | 1 minute ON —1 minute OFF, for 5 |
cycles. Let the appliance cool down for 2 hours before re-using it.
Chopper (if applicable)| 50 g 2 1cm diced meat| 15 seconds On — 2 minutes Off
for 3 cycles.
Leave the appliance to cool for 60 minutes before resuming use.
**WARNING! Comply with the indications in the chapters “Food contact”
and “Quantity and usage time”.
WARNING! Before use, wash all parts which will come into contact with
food.
WARNING! This appliance is not to be used if it has been dropped or if
there are visible signs of damage.
WARNING! Unplug the appliance from the mains supply before changing any
accessory.
WARNING! DO NOT touch the moving parts.
WARNING! DO NOT let the stem support come in contact with food.
WARNING! DO NOT use the chopper with liquids only.
WARNING! Risk of food contamination and damage to the appliance. DO NOT
place the jug in the microwave oven.
WARNING! Risk of food contamination. DO NOT place the chopper bowl in the
microwave oven.
WARNING!** DO NOT exceed the maximum level indicated on the beaker.
- Place the motor body of the hand blender on the stem support, making the triangle symbol line up with the open symbol; turn the stem anticlockwise until the triangle symbol coincides with the closed symbol [Fig. B].
- Fill the beaker with solid and/or liquid foodstuffs without exceeding the maximum level marking.
- Connect the power cable plug to the power socket in the wall.
- Insert the stem until the blades are completely immersed in the mixture [Fig C].
- Press the start button to activate the appliance.
- At the end of the process, release the button and wait for the blades to come to a complete stop.
- Remove the plug from the power socket.
- Empty the container.
- Clean any parts that come into contact with foodstuffs immediately as described in the chapter ‘Cleaning and care’.
USING THE CHOPPER (IF APPLICABLE)
WARNING! DO NOT use the chopper with liquids only.
WARNING! Risk of damage to the appliance. DO NOT insert cheese rinds.
- Fit the blades[Fig. D].
- Fill the bowl with solid foodstuffs without exceeding the maximum level marking indicated on the bowl.
- Fit the lid [Fig E].
- Place the motor body of the hand blender on the chopper lid, making the triangle symbol line up with the open symbol on the lid; turn the motor body anticlockwise until the triangle symbol coincides with the closed symbol [Fig. F].
- Connect the power cable plug to the power socket in the wall.
- Press the start button to activate the appliance.
- At the end of the process, release the speed button used and wait for the blades to come to a complete stop.
- Remove the plug from the power socket.
- Disengage the motor body from the lid and take the lid off.
- Empty the container.
- Clean any parts that come into contact with foodstuffs immediately as described in the chapter ‘Cleaning and care’.
CLEANING AND MAINTENANCE
**WARNING!** Always disconnect the appliance from the socket before
cleaning or performing maintenance.
Clean the accessories according to the table indicated in the chapter Cleaning
before using for the first time.
- Wipe the motor unit with a dampened and thoroughly squeezed out sponge.
- Dry with a dry cloth.
DISPOSAL
The packaging of the appliance is made of recyclable materials. Dispose
of the packaging in accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the crossed bin symbol on the appliance or its packaging indicates
that the appliance must be disposed of separately from other waste at the end
of its useful life.
The user must therefore take the appliance to an appropriate recycling
centre for electrical and electronic equipment. Alternatively, instead of
handling the disposal,
the user can hand over the appliance to the retailer when a new, equivalent
one is purchased. The user can hand over electronic products measuring less
than 25 cm to retailers of electronic products having a sales area of at least
400 m² free of charge and with no obligation to buy.
Appropriate separate collection for the subsequent procedure for the
decommissioned appliance for recycling, which includes treatment and
environmentally friendly disposal, helps prevent adverse effects on the
environment and health and promotes reusing and/or recycling materials that
the appliance consists of.
SUPPORT AND WARRANTY
This appliance is guaranteed for a period of two years from the date of
delivery to the customer.
This date is taken as the date on the receipt/invoice (as long as it is
clearly legible), unless the purchaser can prove that delivery was made at a
later date. In the event of a product flaw already present at the time of
delivery, the cost-free repair or replacement of the appliance is guaranteed
unless one of the two solutions is out of proportion with the other. The
purchaser is responsible for informing an authorised assistance centre about
the conformity flaw within two months of discovering it.
The warranty does not cover parts that may be faulty due to:
a. transport damage or damage caused by accidental falls,
b. incorrect installation or inadequate electrical system,
c. repairs or modifications performed by unauthorised personnel,
d. failure to subject the appliance to proper cleaning and maintenance as
indicated,
e. normal wear of the appliance and/or its parts, and consumables,
f. non-observance of the operating instructions for the appliance, negligent
or careless usage,
g. filling the appliance or using the appliance with foodstuffs that are
expressly prohibited in the instructions (hard, hot, dry foods etc.),
h. use with larger quantities of foodstuffs than indicated,
i. incorrect fitting of blades or accessories,
j. usage exceeding the indicated time limits,
k. accidental infiltration of liquids into the motor base caused by improper
use,
l. a twisted or excessively bent power cable due to negligence.
The above list merely gives examples; it is not complete, as this warranty in
any case does
not cover circumstances that cannot be traced back to manufacturing flaws. In
addition, this warranty is not considered valid in cases of improper appliance
use or professional use. No responsibility can be taken for any harm or damage
caused directly or indirectly to people, pets or property as a result of the
failure to observe all the indications given in the “Instructions and warnings
booklet” with regards the installation, use and maintenance of the appliance.
This does not apply to contract warranty actions in relation to the seller.
Assistance
The appliance may only be repaired by an authorised service centre.
If the faulty appliance is under warranty, it must be sent to the assistance
centre along with a fiscal document proving the date of purchase or delivery.
TYPE R5902 220-240 V 50 Hz 800
W TENACTA GROUP S.p.A.
VIA PIEMONTE 5 IT – 24052 AllANO S. P.
WWW.imetec.com
Tenacta Group S.p.A. Via Piemonte 5/11 24052
Azzano S. Paolo (BG) ITALY
www.imetec.com
References
- Imetec Online Shop - Home page
- Imetec Online Shop - Home page
- Tenacta Group SpA unipersonale
- Imetec Online Shop - Home page
- Tenacta Group SpA unipersonale