PHILIPS G13 LED Tube Universal T8 Light Installation Guide
- June 9, 2024
- Philips
Table of Contents
PHILIPS G13 LED Tube Universal T8 Light
Please take the time to read this installation guide. The guide contains important information and notes regarding the installation and operation.
IMPORTANT
- Always switch off the power supply before commencing work!
- Only to apply in dry indoor usage and environments, outdoor applications requires an IP rated fixture.
- Philips LEDtube is designed to fit in standard IEC compliant G13 bi-pin lampholders.
- Philips LEDtube should be installed by qualified protessionals in accordance with relevant electrical codes.
Does your luminaire have a starter?
This illustration shows its typical location in an open or closed luminaire with the length of 1200 and 1500 mm tubes.
Yes, the luminaire does have a starter.
The luminaire works on ElectromMagnetic ballast. Go to the Electromagnetic
ballast section 2.I Instructions on Electromagnetic ballast
No, the luminaire does not have a starter.
The luminaire works on High Frequency electronic ballast (HF). You need first
to check if the the HF ballast is compatible. To check if your ballast is
compatible, always refer to the latest update of the Philips LEDtube
compatibibility list on www.philips.com/ledtube
- Yes, the ballast is compatible. Go to section 2.2 Instructions on HF compatible ballast
- No, the ballast is not compatible. Go to section 2.3 Instructions for non compatible HF ballast
Instructions on Electromagnetic ballast
Simply replace the old starter with the new (EM) LED starter included in the packaging and follow the instructions below
Instructions on HF compatible ballast
It’s a plug and play solution that works straight out of the box. No need to change drivers or rewire. Quick and easy installation, follow the instructions below
Instructions for non compatible HF ballast
Your luminaire works on High Frequency (HF) ballast, but the ballast is not compatible. Cut wires, remove the ballast and connect direct to mains. Follow the instructions below
- In this application, LED replacement starter is not used.
- Always switch off the power supply before commencing work!
- Philips LED tube should be installed by qualified professionals in accordance with relevant code.
MAKE SURE TO CONNECT LN ONTHE LAMP SIDEWITHLN MARK, OTHERWISE. LAMP MAY DAMAGE
- This lamp may not be suitable for use in all applications where a traditional fluorescent lamp has been used.The temperature range of this lamp is more restricted. In cases of doubt regarding the suitability of the application the manufacturer of this lamp should be consulted
- This lamp is designed for general lighting service (excluding eg. explosive atmospheres)
All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner The information presented in this document does not torm part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use. Publication thereof does not convey nor imply any license under patent or other industrial or intelectual property rights.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>