AMERICAN LIGHTING P1823-44F Conic Chandelier Instruction Manual

LIGHTING P1823-44F Conic Chandelier
Instruction Manual

INSTALLATION INSTRUCTIONS
Item#P1823-44F/248/651(New. 11/02/2019)
READ AND SAVE THESE INSTRUCTIONS

WARNING ! SHUT POWER OFF ATFUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

P1823-44F Conic Chandelier

PREPARATION (Fig. 1)

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
   ASSEMBLING THE FIXTURE WITH BALL SWIVEL (Fig. 2)

3. Determine the desired hanging height and thread rods (F1, F2 and F3) to the threaded nipple of the fixture body (G). Pass the wires carefully through each rod as you
   assemble.

4. Attach the mounting plate (A) to the junction box using mounting screws (B) (Size: #8-32N*L0.5”).

5. Slide the canopy (C) over rods (F) and thread the hanger ball (E) to rods (F). Remove the threaded nipple, if installing with one 6” rod only.

6. Install the fixture body (G) into the mounting plate (A) by tilting at a slight angle so that the hanger ball (E) slips into the mounting plate (A). Align the notch in the hanger ball (E) to the tab on the mounting plate (A) to prevent the fixture from turning.
   CONNECTING THE WIRES (Fig. 3)

7. Connect the electrical wires as shown in figure 3, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect it to  the mounting plate (A) with the ground wire from hanger ball (E). Otherwise, connect the ground wire from the hanger ball (E) directly to the mounting plate (A)  ground wire and secure with the wire connectors provided. After wires are connected, tuck them carefully into the ceiling junction box.
   COMPLETING THE INSTALLATION (Fig. 1)

8. Align the canopy (C) over the mounting plate (A) and secure with screws (D).

9. Install (3) three medium base bulbs up to 100 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification— DO NOT EXCEED  THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)

Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.

a. Hardware Bag:
A. Mounting Plate1
C. Canopy1
D. Screw2
E. Hanger Ball1

b. Hardware Bag:
F1. ROD 6″1
F2. ROD 12″2
F3. ROD 12″*1

LA-3163E

Documents / Resources

| AMERICAN LIGHTING P1823-44F Conic Chandelier [pdf] Instruction Manual
P1823-44F Conic Chandelier, P1823-44F, Conic Chandelier, Chandelier
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>