american lighting association Beacon Avenue Brushed Nickel LED Wall Mounted Lamp Instruction Manual
- October 30, 2023
- american lighting association
Table of Contents
american lighting association Beacon Avenue Brushed Nickel LED Wall
Mounted Lamp
Product Information
The product is a fixture with model numbers 2421-84-L,2422-84-L, 2423-84-L, and 2424-84-L. The fixture comes with a mounting plate set (A-021-114D), ground screw (C), and mounting screws (A). The fixture is dimmable with ELV and/or LED-compatible wall dimmer switch. The installation of the fixture should be done by a qualified electrician.
Product Usage Instructions
- Before starting the installation process, shut off power at the fuse box or circuit breaker box.
- Remove the existing fixture and its mounting hardware if necessary. Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration.
- Attach the mounting plate (B) to the junction box using mounting screws (A) (Size: #8-32*1/2L). The side of the mounting plate marked GND must face out.
- Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw (C) provided. After the wires are connected, tuck them carefully into the junction box.
- Align fixture (F) to the mounting plate (B) and secure with screws (E). Rotate the glass shade (G) into the fixture (F). Do not over tighten.
- After completing the installation, return power to the junction box and test the fixture.
Note: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
INSTALLATION INSTRUCTIONS
For 2421-84-L/2422-84-L/2423-84-L/2424-84-L
WARNING!SHUT POWER OFF AT FUSE ORCIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box. If necessary remove the existing fixture and its mounting hardware.
-
Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration.
-
Attach the mounting plate (B) to the junction box (not included) using mounting screws (A) (Size: #8-32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw (C) provided. After the wires are connected, tuck them carefully into the junction box.
FINISHING THE INSTALLATION (Fig. 1) -
Align fixture (F) to the mounting plate (B) and secure with screws (E).
Rotate the glass shade (G) into the fixture (F). Don’t too tighten.
Your installation is now complete. Return power to the junction box and test the fixture.
CAUTION / ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
Dimmable with ELV and/or LED compatible wall dimmer switch.
Note: Illustration (Fig. 1) on this manual is for installation purpose only. It may be identical to the fixture purchased.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>