AMERICAN LIGHTING P1240 Comet Outdoor LED Ceiling-Wall Light Instruction Manual

June 9, 2024
American Lighting

INSTALLATION INSTRUCTIONS FOR P1240
For Wall Sconce Fixture OR Ceiling Mount
READ AND SAVE THESE INSTRUCTIONS

P1240 Comet Outdoor LED Ceiling-Wall Light

WARNING! SHUT POWER OFF AT FUSE CIRCUIT BREAKER

ASSEMBLING THE FIXTURE (Fig.1 Fig.2)

  1. Shut off power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware.

  2. Carefully remove the fixture from the carton and check that all parts are included as show in Figure 1.
    AMERICAN LIGHTING P1240 Comet Outdoor LED Ceiling-Wall Light
-

  3. Attach the circular strap (A) to the junction box with the two junction box screws (C) (size:8-32*1/2”L) provided. The side marked “GND” must face out CONNECTION THE WIRES (Fig. 3)

  4. Connect the electrical wires as shown in Fig.3, making sure that all wire nuts are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground Wire to it. Otherwise, connect the fixture’s ground wire directly to the circular strap using the green screw(B) provided. Tuck the wire connections neatly into the junction box.
    FINISHING THE INSTALLATION (Fig.1 Fig.2)AMERICAN LIGHTING P1240 Comet
Outdoor LED Ceiling-Wall Light - Ceiling Mount

  5. Align fixture (D) onto circular strap (A), and secure with screws (F) and rubber washers (O). (Please follow the arrow located inside the fixture backplate marked “This side up”). Thread the glass (G) into the fixture and tighten secure with screws (E).
    AMERICAN LIGHTING P1240 Comet Outdoor LED Ceiling-Wall Light -
Fig.3

  6. To prevent moisture from entering the outlet box and causing a short circuit, use clear caulking (i.e. Indoor/Outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall leaving a space at bottom to allow moisture a means to escape (Fig.4).

AMERICAN LIGHTING P1240 Comet Outdoor LED Ceiling-Wall Light -
Fig.4

Your installation is now complete. Return power to the junction box and test the fixture.
CAUTION /ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or back plate (D) only.
Replacing LED module (Fig. 5)
The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached. See installation steps for more details (Fig. 5)
AMERICAN LIGHTING P1240 Comet Outdoor LED Ceiling-Wall Light -
Fig.5 Warning: Turn off power at the circuit breaker before replacing LED module.
a. To remove the fixture from the wall: loosen screws (F) rubber washers (O), disconnect the wire connectors and place the fixture on a clear flat surface.
b. Loosen screws (E) and remove glass (G). Loosen screws (K) to remove ring (J) and panel glass (I).
c. Loosen screw (H), rubber washers (P),screw (M) and wire fastener (N). Carefully remove LED module (L) and graphite gasket(Q).
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

American Lighting User Manuals

Related Manuals