AMERICAN LIGHTING P1356-618 Alluria Pendant Light Instruction Manual

Item#P1356-618 (Rev. 01/16/2020)
READ AND SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS

P1356-618 Alluria Pendant Light

WARNING! SHUTPOWER OF F AT FUSE OR CIRCUIT BREAKER.

ASSEMBLING THE FIXTURE (Fig. 1)

1. Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture, including the mounting hardware.

2. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
   ASSEMBLING THE FIXTURE WITH CHAIN LOOP (Fig. 1)

3. Determine the desired hanging height and thread rods (F1, F2 and F3) to the threaded nipple (I) of the fixture body (J). Screw the loop (H1) onto rod (F1).
   Note: remove the threaded nipple if installing with one 6” rod only.

4. Attach the quick link (G) to loop (H1) and loop (H2) on the canopy (D). Carefully feed the wire through loop (H1), quick link (G,) and loop (H2).

5. Thread screws (A) into the pre-drilled holes in the circular strap (B) spaced the same distance apart as the holes in the canopy (D).

6. Attach the circular strap (B) to the junction box using mounting screws (C) (Size: #8-32N*L0.5”). The side of the circular strap (B) marked “GND” must face out.
   CONNECTING THE WIRES (Fig. 3)

7. Connect the electrical wires as shown in figure 3, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the circular strap (B) using the green screw provided.

8. Tuck the wire connectors neatly into the ceiling junction box.
   IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
   COMPLETING THE INSTALLATION (Fig. 1)

9. Slide the canopy (D) over the screws (A) and secure with knurled knobs (E).

10. Secure rods (K) onto the threaded nipples (L) on the fixture body (J).

11. Install (6) six G9 Xenon bulbs (N) (included) up to 75 watts each, or CFL or LED equivalent, in accordance with the fixture specification. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!). (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).

12. Place the glass shade (O) over the socket and twist to secure it to the socket cup (M).

Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

a. Hardware Bag:
A. Screw2
B. Circular Strap1
D. Canopy 1
C. Mounting Screw2
E. Knurled Knob2
H. Loop1
G. Quick Link*1

b. Hardware Bag:
F1. ROD 12″1
F2. ROD 12″2
F3. ROD 6″*1

LA-2877E

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>