AMERICAN LIGHTING P8141-609-L Discovery LED Pendant Light Instruction Manual
- June 9, 2024
- American Lighting
Table of Contents
AMERICAN LIGHTING P8141-609-L Discovery LED Pendant Light Instruction
Manual
INSTALLATION INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Shut off power at the circuit breaker and remove old fixture including the mounting hardware
SUGGESTED INSTALLATION (Fig. 1)
-
Attach the mounting plate (B) to the Junction box (F) using screws (D) (Screw Size: 8-32*1/2”L). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
-
Connect the driver input wire with housing wire as shown in Fig.2, making sure that all wire connectors (C) are secured.
-
If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided. After wires are connected, tuck them carefully inside the junction box (F).
COMPLETING THE INSTALLATION (Fig. 1) -
Connect the canopy (A) with the mounting plate (B) and secure with mounting screws (E).
-
Adjust the length of the cable to pull or push until the desired length by pushing down(G). Your installation is now complete. Return power to the junction box and test the fixture.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without cutting of
wire and without damage to any decorative element to which the fixture is
attached.
a. Shut off power. Loosen screw (E) to disconnect the canopy (A) from the
mounting plate (B)
b. Disconnect the wire connectors (H) and remove the protective rubber
tube (L)
c. Loosen the wire clip (I).
d. Pushing down the nod (G) and pull the cable wire out.
e. Loosen screw (K) and metal (O) to disconnect the aluminum ring (Q)
(with LED module inside) from the acrylic ring (P)
f. Reverse steps a-e for installing the new LED module and make sure that
all wire connectors (H) are secured and with electronic tape for insulation.
Note: The LED module should be provided by a specified supplier.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>