AMERICAN LIGHTING P8142-609-L Discovery LED Pendant Light Instruction Manual

June 9, 2024
American Lighting

LIGHTING P8142-609-L Discovery LED Pendant Light
Instruction ManualAMERICAN LIGHTING P8142 609 L Discovery LED Pendant
Light

INSTALLATION INSTRUCTIONS
FOR P8142-609-L
FOR LED Chandelier/Pendant Light

P8142-609-L Discovery LED Pendant Light

WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT ! COUPERLE COURANT AU NIVEAU DES FUSIBLES OU DO DISJONCTEUR

HANGING THE FIXTURE

  1. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.

  2. Shut off power at the circuit breaker and remove old fixture including the mounting hardwareAMERICAN LIGHTING P8142 609 L Discovery LED Pendant Light - fig
    SUGGESTED INSTALLATION (Fig. 1)

  3. Attach the mounting plate (B) to the junction box (F) using screws (D) (Screw Size: 8-32*1/2”L). The side of the mounting plate marked “GND” must face out.AMERICAN LIGHTING P8142 609 L Discovery LED Pendant Light - fig1
    CONNECTING THE WIRES (Fig. 2)

  4. Connect the driver input wire with housing wire as shown in Fig.2, making sure that all wire connectors (C) are secured.

  5. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting  plate (B) using the green screw provided. After wires are connected, tuck them carefully inside the junction box (F).
    COMPLETING THE INSTALLATION (Fig. 1)

  6. Connect the canopy (A) with the mounting plate (B) and secure with mounting screws (E).

  7. Adjust the length of the cable to pull or push until the desired length by pushing down the nod (G).

Your installation is now complete. Return power to the junction box and test the fixture.

IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Replacing LED module (Fig. 3 &4)AMERICAN LIGHTING P8142 609 L Discovery
LED Pendant Light - fig2The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached.
a. Shut off power. Loosen screw (E) to disconnect the canopy (A) from the mounting plate (B)
b. Disconnect the wire connectors (H) from the driver and remove the protective rubber tube (L) on the wire.
c. Loosen the wire clip (I).
d. Pushing down the nod (G) and pull the cable wire out.
e. Loosen screws (K) and metal clip (O) to disconnect the aluminum ring (Q) (with the LED module inside) from the acrylic ring (P).
f. Reverse steps a-e for installing the new aluminum ring (Q) and make sure that all wire connectors (H) are secured and with electronic tape for insulation. Connect the wires  of the larger aluminum ring to output wires from the driver (M), as following connect the wires of the smaller aluminum ring to output wires from driver (S) as shown in Fig.4  AMERICAN LIGHTING
P8142 609 L Discovery LED Pendant Light - fig3
Note: The LED module should be provided by a specified supplier.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

American Lighting User Manuals

Related Manuals