AMERICAN LIGHTING P5282-077-L Forest Ice LED Bath Vanity Light Instruction Manual
- June 9, 2024
- American Lighting
Table of Contents
INSTALLATION INSTRUCTIONS FOR
P5282-077-L/P5283-077-L/P5284-077-L
P5282-077-L Forest Ice LED Bath Vanity Light
For Wall Mount Fixture
WARNING! SHUT POWER OFF ATFUSE OR CIRCUIT BREAKER.
PREPARATION
-
Shut off power at the fuse box or circuit breaker box. If necessary remove the old fixture and mounting hardware.
-
Carefully unpack your new fixture and lay out all the parson a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1) -
Use the “key holes” located on the mounting plate (C) as a template to mark the location of the plastic anchors (D) and pre-drill two holes
-
Install the plastic anchors (D) into the wall.
-
Secure mounting back plate (C) to junction box (A) using junction boxes screws (B) (Size: 8-32*1/2”L). The side of the mounting back plate marked “GND” must face out.
-
Align the “key holes” on the mounting plate (C) to the plastic anchors (D) and secure with screws (E).
CONNECTING THE WIRES (FIG. 2) -
At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the back plate (C) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION (FIG.1) -
Fix the bracket (G) to the mounting back plate (C) by using screws (F). Align glass shade (H) into bracket (G) by decorative screws (J) and washers (I).
Your installation is now completed. Return power to the junction box and test
the fixture.
CAUTION/ATTENTION: When handling the fixture, do not apply pressure to
the LEDs. Hold the fixture by the base or bracket (G).
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without cutting of
wire and without damage to any decorative element to which the fixture is
attached. See installation steps for more details (Fig 3.)
a. Shut off power. Remove the fixture from the wall.
b. Remove decorative screws (J) washers (I) and glass shade (H). Remove
screws (F) to disconnect mounting plate (C).
c. Remove screws (K) to disconnect LED module (N) (O) and heat sink (P).
Then release the wires (S) from quick connector (R) on LED module with using
screwdriver (Q) by lightly pressing on the release button located on the top
of the wire connector.
d. Remove screws (M) and washers to disconnect LED module (N) from heat
sink (P).
e. Reverse steps a-d for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
FIG.1
Set # A-021-350118(P5282-077-L);
A-021-530118(P5283-077-L)
A-021-800118(P5284-077-L)
- Mounting plate
- Ground screw
- Mounting screw*2pcs
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV dimmer switches.
american lighting association
Documents / Resources
|
AMERICAN LIGHTING P5282-077-L Forest Ice LED Bath Vanity
Light
[pdf] Instruction Manual
P5282-077-L Forest Ice LED Bath Vanity Light, P5282-077-L, Forest Ice LED Bath
Vanity Light, LED Bath Vanity Light, Vanity Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>