AMERICAN LIGHTING P1229 Droplet LED Bath Vanity Light Instruction Manual
- June 9, 2024
- American Lighting
Table of Contents
INSTALLATION INSTRUCTIONS
Item# P1229
READ AND SAVE THESE INSTRUCTIONS
P1229 Droplet LED Bath Vanity Light
WARNING! SHUT POWER OFF AT FUSE OR CIRUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware.
-
Carefully remove the fixture from the carton and check that all parts are included as show in Figure 1.
-
Thread screws (A) into the pre-drilled holes in the circular strap (B) spaced the same distance apart as the holes in the back plate of the fixture body and secure with hex nuts (D). The length of screws (A) into circular strap (B) may be adjusted if necessary.
-
Attach circular strap (B) to the junction box with mounting screws (C) (size: #8-32N*L0.5”). The side of circular strap (B) marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig.2, making sure that all wire nuts are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground Wire to it. Otherwise, connect the fixture’s ground wire directly to the circular strap using the green screw provided. Tuck the wire connections neatly into the junction box.
FINISHING THE INSTALLATION (Fig. 1) -
Align back plate (E) onto circular strap (B), and secure with ballnuts (F).
-
To prevent moisture from entering the outlet box and causing a short circuit, use clear caulking (i.e. Indoor/Outdoor silicone sealant) to outline the outside of fixture back plate where it meets the wall leaving a space at bottom to allow moisture a means to escape (Fig.3).
Your installation is now complete. Return power to the junction box and test
the fixture.
CAUTION /ATTENTION: When handling the fixture, do not apply pressure to
the LED. Hold the fixture by the base or back plate (E) only. Replacing LED
module (Fig. 4) The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative element to which
the fixture is attached. See installation steps for more details (Fig. 4)
Warning: Turn off power at the circuit breaker before replacing LED
module.
a. To remove the fixture from the wall, loosen ball nuts (F), remove the wire
connectors and place the fixture on a clear flat surface.
b. Remove glass shade (M) from fixture (G) by turning counter-clockwise.
Loosen screws (L) to separate LED cover (K) from fixture (G).
c. Loosen screws (J). Carefully remove LED module (I) and disconnect quick
plug (H) to remove LED module (I).（Fig.4）
d. Reverse steps a-c for installing the new LED module.
Note: The LED module should be provided by a specified supplier.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type dimmers
american ighting association
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>