OLIMPIA SPLENDID Smart 12000 BTU 8000 DOE Dolceclima WiFi Portable Air Conditioner User Manual
- June 9, 2024
- OLIMPIA SPLENDID
Table of Contents
OLIMPIA SPLENDID Smart 12000 BTU 8000 DOE Dolceclima WiFi Portable Air
Conditioner User Manual
SAFETY PRECAUTION
WARNING
- Do not install the Kit in environments with the presence of flammable gases, explosive gases, in very moist environments (laundries, greenhouses, etc.), or in premises where there is other equipment generating a strong source of heat, next to a source of salt or sulphureous water.
- Before proceeding with installation, read the warn- ings indicated on the attached manual for use of the Kit B1020 with care.
INSTALLATION ACCESSORY
Preparation before installation
- Please confirm that all the following parts you have been supply.
| No. | Name | Qty. | Remarks |
|---|---|---|---|
| 1 | Wire controller | 1 | – – |
| 2 | Manual for use of the Kit B1020 | 1 | – – |
| 3 | Screws | 3 | M4X20 (For Mounting on the Wall) |
| 4 | Wall plugs | 3 | For Mounting on the Wall |
| 5 | Kit B1020 | 1 | – – |
| 6 | Cables for connection (group 1) | 1 | Page 5 |
| 7 | Extension cord | 1 | – – |
- Prepare the following assemblies on the site.
| No. | Name | Qty. | Remarks |
|---|---|---|---|
| 1 | Wiring Tube (Insulating Sleeve and Tightening Screw) | 1 | – – |
INSTALLATION METHOD
Dimensions
Wiring Principle Sketch
Wiring figure
- Connect the male joint of the connection cables group-1 to the mainboard, then connect the other side of the connection cables group-1 to the 4-pole screened cable of the smart port.
- If it is desired to extent the wire, please use an extension cord (purchased separately).
Remove the upper part of wire controller Remove the upper part of wire controller
- Insert a flat bladed screwdriver inside the slots in the lower part of the smart port (2 slots) and remove the upper part.
NOTICE
Pay attention not to damage the Smart port with the flat bladed
screwdriver.
Fasten the back plate of the wire controller
-
For exposed mounting, fasten the back plate on the wall with the 3 screws (M4×20) and plugs.
-
Insert the smart kit with slightly strength into the main PCB of the smart port.
Connection
- For exposed mounting, two out letting positions.
- Shielded wiring.
CAUTION
Avoid the water enter into the wired remote controller, use trap and putty to seal the connectors of wires during wiring installation. During installation, leave a certain length of the connection wire to ease the maintenance operations of the Smart port.
Reconnect the upper part of the Smart port
- After adjusting the upper case and then buckle the upper case; avoid clamping the wiring during installation.
SPECIFICATION
| Input voltage | DC 12V/300mA |
|---|---|
| Operating temperature | 0 °C-45°C/32°F-1 13°F |
| Operating humidity | 10%-85% |
| Maximum Transmitted Power | 19.BdBm Max |
| Frequency | WIFl:2.4G |
| Antenna Type | External omnidirectional Antenna |
OPERATION
For the correct use of the Kit, follow the indications described in the attached B1020 manual.
Costumer Support
OLIMPIA SPLENDID spa
via Industriale 1/3
25060 Cellatica (BS)
www.olimpiasplendid.it
info@olimpiasplendid.it
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>