ESR 2G513 HaloLock Power Bank Wallet User Guide
- June 9, 2024
- ESR
Table of Contents
**ESR 2G513 HaloLock Power Bank Wallet
**
Operating Instruction
-
Short press to power on
-
Long press for 3 seconds to manually power off
-
USB-C port
-
Slot for 1 or 2 cards
-
Open stand from here
-
Stand angle adjustment range
Status Light Guide
-
Charging/fully charged
-
USB-C output
-
USB-C input
-
Error detected
Important Reminders
- The power bank only supports magnetic attachment with a caseless iPhone with MagSafe, an official MagSafe case, an ESR HaloLock™ case, or a standard case with a HaloLock™ Universal Ring. It may not attach to other magnetic cases. It will not attach to any other non-magnetic phones or cases.
- While the power bank is being charged, it can still wirelessly charge your phone. The maximum output of the power bank is 7.5W for wireless charging. The USB-C port has a maximum input of 12W and a maximum output of 12W.
- The power bank does not support simultaneous wireless and wired charging. If a device is plugged in and a phone is magnetically attached, the power bank defaults to wired charging. The device that is magnetically attached will not be charged.
Safety Warnings
-
Do not expose the device to temperatures below 0°C (32°F) or above 60°C (140°F).
-
Do not expose the device to an open flame or submerge it in water as this will
damage the device. -
Always check for damage to the device, cables, or other accessories before using the device. If damaged, do not use the device.
-
Do not attempt to disassemble or modify the device in any way, as it may cause serious damage and void the warranty.
-
Do not expose the device to corrosive liquids, or high humidity as they will seriously damage the device and void the warranty.
FCC ID: 2APEW-2G513
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &your body.
Declaration of Conformity
This product complies with the radio interference requirements of the European Community.
This product is intended for use within Europe. Electronic Silk Road Corp. hereby declares that this product 2G513 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU,2014/35/EU,2014/30/EU. The Declaration of Conformity for the 2G513 is available from www.esrgear.com
This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Customer Support
Scan to watch a quick setup video