Cell2 UR04 Led Flush Mount Kit User Guide
- June 9, 2024
- Cell2
Table of Contents
UR04 Led Flush Mount Kit
User Guide
CONTENTS
WIRING & FUNCTIONS
OPERATION
For Simultaneous or Alternating Synchronization:
-
Apply +VDC to RED and YELLOW wires simultaneously to enter Flash Mode Selection.
-
Remove YELLOW wire from +VDC and momentarily apply to +VDC to change mode selection:
Mode 1 = Head 1 & 2 flash alternately
Mode 2 = Head 1 & 2 flash simultaneously -
Exit Flash Mode Selection by removing +VDC.
For Flash Pattern Selection:
Momentarily apply +VDC to YELLOW wire
Once to next pattern
Quick three times to FP#1 (see Flash Pattern Chart)
| FP# | Flash Patterns |
|---|---|
| 1 | Single [2Hz] |
| 2 | Double [R65]* |
| 3 | Triple [2Hz] |
| 4 | Quad [2Hz] |
| 5 | Random |
| 6 | Single |
| 7 | Double |
- Actual approval will be based on the model purchased.
** In Mode 2, lightheads will both steady-burn; in Mode 1, one lighthead will steady burn while the other does double flash.
INSTALLATION – FLUSH MOUNT
-
Select a mounting location and drill one 1″ (25.4mm) cut-out.
NOTE: Mounting surface thickness @ 0.8~2.0mm
-
From the front, install MOUNTING GROMMET onto the cut-out, and then insert the LIGHTHEAD.
-
Ensure that triangle mark on the lens is aligned vertically.
-
Where necessary, apply silicone around the reverse side to prevent from rotating.
INSTALLATION – BRACKET MOUNT (sold-separately)
-
From the front, install the MOUNTING GROMMET onto the BRACKET, and insert the LIGHTHEAD.
-
Ensure that triangle mark on the lens is aligned vertically.
-
Secure the LIGHTHEAD onto the BRACKET with a screw.
-
Secure the BRACKET onto the desired mounting surface with screws.
WIRING 2 KITS TOGETHER
Below is a schematic diagram for wiring 2 kits together.
YELLOW wires from both controllers must be connected together for
synchronization.
- If Mode 1 is selected: Head 1A&2A will flash alternately with Head 1B&2B.
- If Mode 2 is selected: All Heads will flash simultaneously.
- Refer to Flash Pattern Chart on the opposite page.
NOTE: To have Head 1A&2B alternate with 1B&2A, simply reverse the lighthead outlets on one of the Controllers; (both kits must be in Mode 1).
NOTE: The mounting area varies from vehicle to vehicle. (The diagram is not drawn to scale)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>