MEAN WELL PLD-40 Series 40W Single Output LED Power Supply Owner’s Manual
- June 9, 2024
- MEAN WELL
Table of Contents
MEAN WELL PLD-40 Series 40W Single Output LED Power Supply Owner
Features
- Built-in active PFC function
- Constant current design
- Protections: Short circuit/ Over temperature
- Cooling by free air convection
- Fully isolated plastic case
- IP42 design
- Class I power unit, no FG
- Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
- 100% full load burn-in test
- Low cost
- High reliability
- 3 years warranty
SPECIFICATION
NOTE
- Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
- Direct connecting to LEDs is suggested, but is not suitable for using additional drivers.
- To fulfil requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently connected to the mains.
- The ambient temperature derating of 3.5 C/1000m with fanless models and of 5C/1000m with fan models for operating altitude higher than 2000m(6500ft).|
- For any application note and P water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
x Product Liability Disclaimer: For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx
40W Single Output LED Power Supply
Mechanical Specification
Block Diagram
Derating Curve
Static Characteristics
Power Factor Characteristic
FFICIENCY vs LOAD (PLD-40-500B)
PLD-40 series possess superior working efficiency that up to 88% can be
reached in field applications.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>