Sea Gull Lighting 65436 Academy Pendant Instruction Manual
- June 9, 2024
- Sea Gull Lighting
Table of Contents
65436 Academy Pendant
Instruction Manual Installation Instructions for
Academy Pendant
NEED HELP?
GENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE
– This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of
the product and the hazards involved. This product requires installation by a
qualified electrician.
Use minimum 90°c supply conductors.
**** If you need installation assistance, replacement parts, or have
questions regarding our warranty, please call our customer care center:
1-800-347-5483
To register your fixture, please visit our website:
SAVETHESE INSTRUCTIONS!
www.SeaGullLighting.com
Warranty
Sea Gull Lighting fixtures and components, when properly installed and under
normal conditions of use, are warranted to be free from defects in materials
and workmanship for one year from date of sale. LED light sources are
warranted for five years. ENERGY STAR® labeled products are warranted for
three years.
Sea Gull Lighting at its sole option will repair or replace, F.O.B. Factory,
freight prepaid, any Sea Gull Lighting product defective in materials or
workmanship.Such replacement is the exclusive remedy against Sea Gull Lighting
should any of the products delivered prove defective. Invoices for labor
charges and/or charge backs for labor will be denied unless prior written
approval is given.
Any modification to a Sea Gull Lighting product not made at the factory will
void the or UL ETL listing as well as the Sea Gull Lighting warranty policy.
To register your fixture, please visit our website:
SeaGullLighting.com
Install the Fixture
- Secure the mounting plate to the electrical box with two mounting plate screws.
- Determine the wanted height or look of the fixture with the provided stems and/or chain ans assemble them by screwing them together. All the parts may be used alone or used in combination. Note: At least 1 12” stem must be used to allow sufficient space for wiring.
- Feed the fixture wires through the stems/chain (for chain only this may done after complete assembly).
- Feed the fixture wires through the canopy and tightly screw the stem assembly to the canopy.
- Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Align then place the fixture base onto the mounting plate studs and secure it with the two ball nuts.
- Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
- Place the shade into the shade base and secure it tightly with the shade screws.
CAUTION: Over tightening the screws may cause the glass to break resulting in injury.
7400 Linder Ave, Skokie, 60077 IL
800.323.3226 – 847.626.6300
www.SeaGullLighting.com
© 2017 Sea Gull Lighting.All rights reserved.The “Sea Gull Lighting” graphic
is a
registered trademark of Sea Gull Lighting. Sea Gull Lighting reserves the
right to
change specifications for product improvements without notification.
A Generation Brands Company
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>